|
|
|
|
|
#1
10-15-2021, 06:06 PM
|
|||
|
|||
|
W123 R4 Bolts and Spacers
Tried to search this one to avoid multiples, but just couldn't find an answer.
LOOOONG story short, my 85 W123 300D needs a new compressor. I went with just replacing the frozen up R4 that was there. However, thangs happen and I need new bolts and spacers. I found a size for replacement bolts, but I can't find any info on the spacers. If anyone could tell me, I'd greatly appreciate it! Bobby Tulsa, OK
__________________
85 300D 
|
|
#2
10-15-2021, 08:03 PM
|
||||
|
||||
|
Oh boy.
I’ve been there. There are two approx one cm thick spacers and a bracket spacer (not exactly sure what to call it) that’s a few inches (photos are abundant). For grip, there’s also a wave washer on the cap end of each bolt I lost one of the smaller spacers and after utter failure to procure said info, found the bits at a local JY. That wasn’t much help… good luck.
__________________
1981 240D 4sp manual. Ivory White.
|
|
#4
10-15-2021, 09:03 PM
|
||||
|
||||
|
I suppose I could pull a set, and measure them for ya…
__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread "as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do! My drivers: 1987 190D 2.5Turbo 1987 560SL convertible 1987 190D 2.5-5SPEED!!!  1987 300TD 2005 Dodge Sprinter 2500 158"WB 1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere!
|
 |
| Bookmarks |
|
|
Linear Mode
