I picked up an '85 300SD.. Running and Rusty for $800..

I can easily use and offload enough parts to break even on it-- but was considering it for a "winter car" this winter in Ohio, to attempt to keep my '84 SD "clean and pristine..."

I bought it with two known problems

1) fuel leak-- I drove it home using a gallon oil can, filled with diesel, leaving the filters, inline, and the return tube going into it.. Yeah, less than beautiful-- but less hassle than putting it on a tow dolly, and assured me it IS a running rusty beast, with no other "readily apparent" problems..

2) the rear end howls (okay that's an over estimate) iirc correctly, I heard it in neutral as well-- leading me to think it's a wheel bearing or halfshaft/cv joint..

Since I've done NEITHER on a 126, I wondered if anyone had any good "diagnosis" tips, and "hints" on getting it apart...

Again-- if it's a serious hassle, I'll drive her till she drops, tow her home and start "harvesting" her parts..

Just wondered if someone could give me some direction..

__________________
Agnes (the Limo) '84 300SD
Pearl (the Taxi) '81 240D (preparing for the 'afterlife')
Bridgette (baby girl) '82 VW Pickup-- currently getting readied for her rebuilt (overbored) engine.
1 VW 1.6 NA diesel **not installed in vehicle**
Gidget (the bimbo) '87 VW Cabriolet-- the diesel engine it above is eventually going there!

and a BMW Motorcycle. (1998 R1200C)

Did I mention I'm of German Heritage??