Looks like both engine mounts are next in my series of catching up on the list of deferred maintenance items on my SDL. I plan on changing the transmission mount at the same time and the engine shocks and grommets on both sides.

I've done the mounts already on my 300D - I'm hoping the steps are similar, though I've never replaced the transmission mount before - not sure what the steps are. I've tried to lookup the FSM procedure on the mounts, but the manual only talked about a function of the motor mounts not how to remove them.

I plan on following DieselGiant's steps as part of the oil cooler line replacement process for 617 - I have some questions specific to the SDL:

1) Is it ok to jack up the engine by placing a sturdy block of wood under the oil pan?! The pan is aluminum and the engine is a beast, so I wanted just to make sure.

2) The FSM mentions the engine stop adjustment?! Does my engine have an engine stop that I need to worry about before I start to jack it up? Not even sure what that looks like...

3) How far up should I lift the engine? On my 300D I wasn't sure either and was advised here to take off the fan shroud and jack up until the back of the valve cover hit the firewall - it was a good advice. It worked well.

4) Are there any steps describing the R&R of the transmission mount on the SDL?!

__________________
1987 Mercedes 300SDL; SOLD
1985 Mercedes 300D; SOLD
2006 Honda Pilot - wife's ride; 122K;
1995 Toyota Land Cruiser - 3X locked; 182K