On the 3 injector it's looks like I'm miss a washer because all of the other injector holes have it. Any help is welcome

I believe you are talking about the crush washers that are only used once when you take out your injectors. If that is the case, you will need to replace all off them. They are pretty cheap, but it would also be a good idea to clean your injectors and have them pop tested while they are out.

__________________
Professional greasecar installer
Austin TX


98 Jetta TDI with grease car kit + veg-therm (totaled)
87 MB 300SDL running on B99 / greasecar kit + 30 fphe
www.austingreaseguys.com

Well I'm talking about the gold looking peace in the injector hole after you pull the injector

That is called a heat shield, and they are like the crush washers...need to be replaced after an injector is pulled out.

__________________
RRGrassi


70's Southern Pacific #5608 Fairmont A-4 MOW car

13 VW JSW 2.0 TDI 193K, Tuned with DPF and EGR Delete.

99 W210 E300 Turbo Diesel, chipped, DPF/Converter Delete. Still needs EGR Delete, 232K

90 Dodge D250 5.9 Cummins/5 speed. 400K

Gone and still missed...1982 w123 300D, 1991 w124 300D

Make sure there isn't one in there, not just stuck.

__________________
1983 240D 3.0T 4-speed manual, now sold

1989 Subaru GL Wagon 5-speed Touring Edition

Ok do I need to get them at the dealer or would napa have them? Also do I need the crush washers? If so where do they go because it doesn't look there are any washers on these injectors right now

I have a pic I took on my phone but I can't upload it

There aren't your typical crush washers persay, they are heat shields but also crush washers that seal up to the injector nozzle. There should be one in each hole for the injector. They are glorified washers that need to be replaced each time intjectors are installed. They protect the inject nozzle from the heat of the engine. Sometimes they come out with the injector sometimes they stick to the bottom of the hole and have to be pulled out.

__________________

NAPA won't have 'em, but internet warehouses will, click on the "BUY PARTS" button at the top.

__________________
83 SD

84 CD

The heat shield is item #53 in the pic.
The new heat shield will most likely not be plated and be a black or grey color.
The older VW Rabbit Diesles and my Volvo Diesel use the same Heat Shields.
NAPA shows them on their internet site. they have the large and small holed ones. (I looked it up for my 84 300D.)
I did a search for "injector" and along with Injectors it was listed listed as: Diesel Fuel Injector Heat Shield

Attached Thumbnails

 

__________________
84 300D, 82 Volvo 244Gl Diesel

Thank you all for your help