|
|
|
#1
|
|||
|
|||
How do you clean 240D oil/seperator
I am wondering if there is a way to take the vapor/oil seperator apart and clean it out...I got some blowby and the trap/seperaotr must be clogged because the drain pipe going into it weaps...Does anyone have any pics of one of these apart???
Thanks in advance! I also saw this post in another thread, and it got me really curious? IF the seperator is plugged up the engine has to breath/vent pressure...could be pushing oil passed? If there are vacuum problems and excessive blowby, then the vacuum lines and booster are the first places to look, especially if the engine starts and runs fine. For a quick test, disconnect the union on the pump hard line before the barbed fitting and plug it on the pump end. If your blowby decreases greatly, the issue is not an internal one.
__________________
1982 300SD 1984 300SD 1990 Chevrolet Suburban 4x4- 6.2L diesel Banks Turbo 1984 Chevrolet 4x4 M1008- 1 1 /4 ton, 4.56's, 6.2L 49K, NOW sporting a performance built 700r4 overdrive. Sold 82 240d 81 240d 83 300Td 84 300D turbo Last edited by btrapr; 03-14-2010 at 06:38 PM. |
#2
|
||||
|
||||
I dont think you can clean them
__________________
1985 Euro 240D 5 spd 140K 1979 240D 5 spd, 40K on engine rebuild 1994 Dodge/Cummins, 5 spd, 121K 1964 Allice Chalmers D15 tractor 2014 Kubota L3800 tractor 1964 VW bug "Lifes too short to drive a boring car" |
Bookmarks |
|
|