![]() |
|
|
|
#1
|
|||
|
|||
ignition problem 240 D
update 12/6 - I found the problem, it was the ignition start switch, got another one
and everything works now. Don update 12/3--- I have traced the circuit ffrom the starter to the light switch then over to the ignition switch. I get nothing out of 15 when I turn the key. my question is do I have to replace the whole ignition switch????? or can I just replace the tumbler or is there a way to clean the tumbler????? tks, Don I had a thread this summer on restoring my 1975 240d. It had a bad engine and I recently put in a used one. The problem I have now, I have to run a jump wire on the fuse buse on the engine firewall from fuse 1 to 2 to get pwr to the ignition switch. I have traced the power from the battery to the starter and then to the light switch on the dash. I assume from the light switch it goes over to the ignition switch???? I would appreciate if anyone could send me the circuit or tell me the flow and what to check to correct this problem. tks, Don ![]() Last edited by don haw; 12-06-2001 at 08:13 PM. |
#2
|
|||
|
|||
If you are in the US, you can order a CD that has all of the wiring diagrams you need for this vehicle.
__________________
Benzmac: Donnie Drummonds ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 11 YRS |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
190E 2.3 16V Ignition tumbler problem | mnoll4060 | Tech Help | 8 | 11-23-2004 11:49 PM |
86 190 E strange ignition problem | derdiesel | Tech Help | 1 | 03-09-2004 03:25 PM |
240 d odometer problem | Printprocc | Diesel Discussion | 3 | 01-20-2004 12:04 PM |
S500 intermittent problem | Edamartin | Tech Help | 4 | 06-10-2003 11:49 AM |
ignition switch problem | colinr | Tech Help | 2 | 06-20-2002 02:30 PM |