IP timing. tool vs lining up teeth.

10-15-2010, 08:47 PM

spamman450 spamman450 is offline

Registered User

Join Date: Mar 2005

Location: Vista, CA

Posts: 345

IP timing. tool vs lining up teeth.

I am in the process of installing the injection pump on my project wagon motor. Now i have a tool that screws into a port on the side of the pump, however when it is installed, the mark on the pump housing is not lined up with the space in the teeth. This is where i am confused. do i go with the tool, or with the teeth? Not too much info on the tool out there so i though i would ask.

__________________

1979 240D with a 617 turbo diesel.

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

All times are GMT -4. The time now is 09:22 AM.