|
|
|
|
|
|
|
#1
10-20-2010, 06:13 PM
|
|||
|
|||
|
what is the socket cap screw for in bearing kit
I ordered bearing kits for a 1985 300sd and don't know what the screw is for...
see photo from Fastlane online catalog...
__________________
1985 300SD 
|
|
#2
10-20-2010, 06:47 PM
|
|||
|
|||
|
Quote:
|
|
#3
10-20-2010, 07:08 PM
|
|||
|
|||
|
Oh wow, slipped right by me...
Thanks. not sure why my photo attachment did not show up on last post. will try again with this message. OK, i see why, the dialog box asks to please wait while uploading... I closed the box too soon.
__________________
1985 300SD
|
|
#4
10-21-2010, 02:10 AM
|
||||
|
||||
|
I believe that there is an adjusting nut on the spindle that you tighten to set the specified play in the rotor, and the socket cap bolt goes through the periphery of that nut to lock it at the position you set. Have you taken the grease cap off yet? It should be relatively obvious at that point.
Kurt
__________________
- '79 240D - engine swap complete! Engine broken in! 28-31 mpg! Lovin' the ride! - '86 190D (W201-126) - 2.5 NA engine, 5 speed, cloth interior, manual climate controls, 33-34 mpg (sold to forum member).
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
