Next course of action: injection timing or injectors? - PeachParts Mercedes-Benz Forum

Diesel911 · #1 08-05-2011, 06:08 PM

Quote:

Originally Posted by bipolardave

Thanks for the advice.

However, I can't even get the bubble to collapse with the hand pump before I fire it off. It's been that way since I put everything back together. A bad lifter pump wouldn't maifest itself until after the car is running, no?

It was fine before I played "Adventures in Compression Testing". There was only a small bubble in the primary filter then.

For what it's worth, I had to replace the hand pump because it failed. That initial start up after the compression check was difficult because I couldn't bleed the lines.

As to the pnuematic governor...I have a clear plastic line running from the back of the IP to the breather. Would that be it? If so, how can one check for failure? I understand that it serves as the load line for the IP.

I PMed you some info on the Pneumatic Governor. I do not know how to trouble shoot them.

Actually if the Lift Pump Valves were leaking or the Pump Piston was worn (it does not happen very often that the Pump Piston gets worn unless dirt went thriough it; when that happens the sides of the Piston get scored up) it would be more noticable at idle speeds than at higer rpms.
Because Fuel has more time to leak past at idle speed and the Fuel Volume per minute is lower.

If you look at that info I sent there is some test proceedures for the Fuel Supply/Lift Pump; although not for your specific year.

junqueyardjim · #2 08-05-2011, 06:35 PM

Hey don't worry about a big or little bubble in the primary filter. They all have that! That is not a problem so just overlook it if it spooks you.

junqueyardjim · #3 08-05-2011, 06:40 PM

Also Dave, your compression shows at the lowest level of "good". If you did a "warm" compression test and gave it 7,8 or 9 strokes and all you got is 290/300, that is too low to really run good. Have you had that car on the road for 30 to 50 miles of hard running, I mean pouring the cobs to it, but don't get a ticket. It might do a lot for that engine.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode