|
|
|
#1
|
||||
|
||||
Its summer--No a/c 98 e300d
When I turn on air I get a few minutes of cold air and then it starts blowing hot air. Is this a dryer problem?
__________________
1998 E300Turbodiesel 1980 300d Ready- Ronnie |
#2
|
|||
|
|||
Have you checked the Actual Values using the CCU? Screens 1-7?
Pulled the HVAC error codes from the CCU? Can be many things. The values and codes ought to lead you in the right direction.
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.) |
#3
|
||||
|
||||
Pulling codes
Pulling the codes is something I will have to brush up on. It's been a long time since I read how to do that
__________________
1998 E300Turbodiesel 1980 300d Ready- Ronnie |
#4
|
|||
|
|||
Your symptoms are typical of a faulty evap temperature sensor. Codes will confirm it. Go into the diag display then start the car. Watch #5 it should drop toward a reasonable value, e.g. 40 degrees. If it stays way out of range the system will shut off the compressor after a few minutes.
|
#5
|
||||
|
||||
quick primer on how to pull diagnostics on a W210 climate control
With the car running and the AC on - hold in the REST button until the display shows 1 on the left and some numbers on the right - push the left AUTO button until the item you want to check is on the left - push the right AUTO button to go backwards in the item list - push the REST button again to exit. you want to look at item 5 which is evap temperature in degrees F. 7 is refrigerant hi-side pressure in bar (1 bar is 14.7 psi) Google w210 climate control codes for the rest of the story
__________________
The OM 642/722.9 powered family Still going strong 2014 ML350 Bluetec (wife's DD) 2013 E350 Bluetec (my DD) both my kids cars went to junkyard in 2023 2008 ML320 CDI (Older son’s DD) fatal transmission failure, water soaked/fried rear SAM, numerous other issues, just too far gone to save (165k miles) 2008 E320 Bluetec (Younger son's DD) injector failed open and diluted oil with diesel, spun main bearings (240k miles) 1998 E300DT sold to TimFreeh 1987 300TD sold to vstech |
#6
|
|||
|
|||
Not to take over the thread but I pulled the following codes
B1231 B1234 B1235 I get some ac then heat or turns off all together and always hot on driver side when the passenger is cold no ac in rear or mid console ! any idea where to start ?
__________________
2003 GX470 1998 E300 3.0TD 2002 Dodge 2500 4x4 cummins 1998 Dodge 3500 5 speed Cummins |
Bookmarks |
|
|