Diesel soot and NOx is bad for you. Not as bad as smaller particulate matter, but it ain't good. In NYS, school busses are no longer allowed to idle more than 5 minutes when waiting.

In buffalo the neighborhood near the Peace bridge (canadian border crossing) has well document and long standing high prevalence of athsma and other lung problems. This is caused by the NOx and soot from trucks waiting for customs clearance.

Geographic Clustering of Adult Asthma Hospitalization and Residential Exposure to Pollution at a United States

__________________
CC: NSA

All things are burning, know this and be released.

82 Benz 240 D, Kuan Yin
12 Ford Escape 4wd

You're four times

It's hard to

more likely to

concentrate on

have an accident

two things

when you're on

at the same time.

a cell phone.

www.kiva.org It's not like there's anything wrong with feeling good, is there?

not to mention... Working on a w116 is a breeze compared to working on any modern junk.
Room to reach in, Quality fasteners that don't turn to dust when you need to remove them and so on. Mercedes cars of this era were designed to be repaired rather than most of the jap crap that was designed to be easily assembled, used then junked.

__________________
Current fleet
2006 E320 CDI
1992 300D - 5speed manual swapped

former members
1984 300D "Blues Mobile"

1978 300CD "El Toro"

these are the last of the all hand built mercedes cars... they are a treasure...

__________________
1981 NA 300D 310k miles

Agree. The 300SD W126's look like pimp mobiles too. :-)

It looks nice. But before you plonk down 6 g's for this vehicle you need to inspect it closely in person. Rust is the #1 thing to look for. Unless its lived its entire life in the desert it has rust. And as Mercedes Benz service advisor told me many years ago now "on these car's it's not the rust you can see that you need to worry about".

The kick panel next to the drivers and passengers feet needs to be removed and you need to see what lies behind that. The carpets need to be removed and dampness/rust looked for beneath them. As do the rear seats. They are easy to pull out. Just a couple of clips at the base of the seat to push and the whole thing pulls straight out. Check beneath and beneath the rear carpets to see the condition of the floor.

Take a screwdriver or something and poke up at the underside of the body, right beneath the drivers and passengers feet. Should be solid. The undercoating can harden over the decades and deteriorate allowing water to get in and attack the metal. If they screwdriver penetrates you have a problem. Not necessarily a terminal one but you need to check thoroughly.

These are an awesome car, in verifiably good condition. In comparison a Honda Accord (bizarre that one would even compare the two) is a piece of crap.

- Peter.

__________________
2021 Chevrolet Spark
Formerly...
2000 GMC Sonoma
1981 240D 4spd stick. 347000 miles. Deceased Feb 14 2021
2002 Kia Rio. Worst crap on four wheels
1981 240D 4spd stick. 389000 miles.
1984 123 200
1979 116 280S
1972 Cadillac Sedan DeVille
1971 108 280S

Thanks Peter.

What else can one buy for $2500 in the rust belt? My car has needed work because it was owned by a frail old lady and it sat for a long time. Just make sure if you buy the car that it is actually in like-new condition as far as all the little things go. Things that a person can maintain over time. Otherwise you're getting ripped off.

I don't plan to keep the car any longer than I have to. I'm thinking about buying a 2006 ML350 to be honest. Can get them here for $8000 with 125,000 KM on them. Still will have things to repair, but it won't be an avalanche of repairs like it is with a 35 year old vehicle. Not to mention starting easy in winter, not using dirty greasy diesel fuel, and all the safety innovations.

I've been a DIY mechanic going on 25 years now. I don't enjoy crawling under cars and feeling like I've been beaten with a crowbar for days on end. Sick of it. If you have money to pay somebody else a fortune to do all these repairs then that's cool. I'd rather have a new car.

__________________
1987 300E

My car isn't a turd either. I looked for months for a good one. People stop me constantly to fawn over it.

SO even though the car looks good. You have no idea what it might have in store for you.
I knew the car would need work when I bought it, but it's been a challenge to keep up. I think most stuff is done now. Maybe a bit more brake work, and the rear axle boots need replacing, but otherwise the car is really a low mileage car, and it runs and drives really good for the age.

I would probably try to get $4500 for mine if I sold it at this point. I could not find another that had anywhere near the amount of effort put into it that mine has in the last 6 months. Plus it has new tires. I guess $6000 isn't a bad price if the car is really superb, but I doubt it is.

Attached Thumbnails

 

__________________
1987 300E

That's another thing, make sure the tires are good. The DOT code prior to 2000 used the last 3 digits to tell the week (2 digits) and the year of manufacture (1 digit). Newer tires use 4 digits, so the last two digits are the year. You don't want tires more than 6 years old. They will be hard and a hazard on wet roads.

__________________
1987 300E