My inlet pipe fell apart and chewed up my compressor wheel on my 08 ML320 CDI. In rebuilding the turbo all 5 of the vane bracket bolts broke. I can't seem to find any place that sells these bolts. Before going to the hardware store and making something work does anybody know where I can get these little torx head bolts?

Hello and welcome to the forum! If our members don't chime in or have a source; feel free to give us a call at 888-280-7799 and one of our MB part specialists may be able to help or suggest an alternative. Hope this helps and best of luck!

Do you have a Fastenal store nearby?

Also just FYI the big bolts holding the turbo to the oil tower are stretch to yield, so they are one-use bolts. Factory torque spec is something in the high double digits +90 degrees. That is a dead giveaway its a stretch to yield bolt.

__________________
The OM 642/722.9 powered family
Still going strong
2014 ML350 Bluetec (wife's DD)
2013 E350 Bluetec (my DD)

both my kids cars went to junkyard in 2023
2008 ML320 CDI (Older son’s DD) fatal transmission failure, water soaked/fried rear SAM, numerous other issues, just too far gone to save (165k miles)
2008 E320 Bluetec (Younger son's DD) injector failed open and diluted oil with diesel, spun main bearings (240k miles)

1998 E300DT sold to TimFreeh
1987 300TD sold to vstech

I do unfortunately I don't have any good bolts to take in with me to show them what I'm looking for. If I had dimensions I could find them and order them but was hoping to find replacement bolts. I can't imagine I'm the only one that has broken them off.