I ruined my MT in my 1982 240D by losing all the ATF over a period of years. I got a junkyard tranny from an '83 240D said to be good and I put it in today. 1.2.3.4 all shift fine move the car in the garage but I have no reverse. The third shifter was a little bent and I replaced it with the reverse lever from my dead tranny. I did have to loosen the clutch slave feed line slightly and lost a tiny bit of fluid. Did I monkey with the lever adjustment? I have a likely unrelated vacuum issue because the car wont shut off as I must have pulled off the IP shut off line. Any ideas out there in guru land?