Hi,
Dealer replaced the actuators on my 94 E500. Back end felt spongy thereafter. I readjusted the ride height via the self-leveling to the point at which it was before actuator failure.
I am not sure that I have things in spec.
Does anyone know the factory procedure to adjust rear ride height. Also, does anyone know what the average ride height should be. The only dimension I have used for this is the distance from Centre Star on of the wheel cap to bottom of fender lip vertically.
Before actuator failure the distance was 14.75". If I recreate this distance the back end feels mushy. It feels best at 15.25, but this creates too much lateral sway, indicating that it might be too high. And I am fed up playing with it...
Thanks and regards
farrukh