My 1999 ML430 is creaking bad when right rear suspension moves up and down. I believe it is the lower ball joint after inspection. There is excessive movement in the right rear joint and lubricant is leaking out.




I have a ball joint on order.
It appears to be a press in type of ball joint.
I am seeking advice on how to replace this type of joint.
Is there a specific tool I should use?
Heating necessary?

1999 ML430 82K miles

The original ball joint is pressed in, but the replacement is held in with a slotted nut. OF course you need a special tool to tighten that nut! MB number 385-589-00-07-00. TORQUE on that nut is 300NM!

__________________
MERCEDES Benz Master Guild Technician (6 TIMES)
ASE Master Technician
Mercedes Benz Star Technician (2 times)
44 years foreign automotive repair
27 Years M.B. Shop foreman (dealer)
MB technical information Specialist (15 years)
190E 2.3 16V ITS SCCA race car (sold)
1986 190E 2.3 16V 2.5 (sold)
Retired Moderator

Thanks M. B. Doc

Ball joint replacement is done, but not without help. I ended up taking off the knuckle assembly and having a machine shop press in the new ball joint.

DIY Lessons learned:
1) The base plate is not to be used to pull in the ball joint or the threads will get stripped.
2) Machine shop can extract the old joint and press in the new joint without having to get to the other side of the knuckle assembly, so the parking brake assembly and disc cover could possibly be left alone (I took the parking brake assembly completely off - not sure about cable attachment if left on).
3) An alternative to fitting a stubby hex key wrench in the cramped space above the joint is to remove the rubber dust cover and clamp a vice down on the middle of the joint.
4) There was a Torx T45 size slot at the top of the new ball joint bolt. In order to get something to fit up there I had to cut off approx. 1/4" of a T45 bit. I held the ball joint bolt steady with a 5/16" box end wrench holding the T45 bit and screwing on the nut with a 21 mm open end wrench.