Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 2 1 2
Showing results 1 to 30 of 40
Search took 0.03 seconds. Search: Posts Made By: TZ_280SEL
Forum: Vintage Mercedes Forum 04-02-2025, 11:49 AM
Replies: 2
Views: 3
Posted By TZ_280SEL
Keep in mind that the away bar bushings are held...

Keep in mind that the away bar bushings are held in place by the bolts that locate the front of the “leaf springs” (which are not springs). That means when you remove those fasteners (one is...
Forum: Vintage Mercedes Forum 02-20-2025, 07:46 AM
Replies: 1
Views: 46
Posted By TZ_280SEL
Don’t forget a front end alignment after. The...

Don’t forget a front end alignment after. The “leaf springs” are the coarse camber adjustment.
Forum: Vintage Mercedes Forum 11-15-2024, 02:00 PM
Replies: 17
Views: 1,397
Posted By TZ_280SEL
I attempted to purchase some raw MB Tex from...

I attempted to purchase some raw MB Tex from them. After A few weeks with no response, I purchased it from GAHH. Was a bit disappointed that the cognac Tex from world upholstery is different than...
Forum: Vintage Mercedes Forum 06-15-2024, 09:31 AM
Replies: 3
Views: 342
Posted By TZ_280SEL
I replaced my control module with a Pertronix...

I replaced my control module with a Pertronix unit. It performed very well until I decided to switch everything to megasquirt about 6 years ago.
Forum: Vintage Mercedes Forum 11-08-2023, 10:26 PM
Replies: 18
Views: 3,022
Posted By TZ_280SEL
I am running the standard 3.27 rear end and the 3...

I am running the standard 3.27 rear end and the 3 speed. I’m controlling spark and fuel using a 36-1 crank wheel and Hall effect. No more distributor. I’m running GM LS-2 coil-near-plug and modern...
Forum: Vintage Mercedes Forum 11-08-2023, 08:47 AM
Replies: 18
Views: 3,022
Posted By TZ_280SEL
I have a W108 with M117 which is running modern...

I have a W108 with M117 which is running modern EFI (Megasquirt). I use it as a daily driver. My weekly commute is about 400 miles and I drive this car about half the time. The modern EFI really...
Forum: Vintage Mercedes Forum 08-29-2023, 02:16 PM
Replies: 12
Views: 952
Posted By TZ_280SEL
Hankook Optimo H724 All-Season Tire - 195/75R14...

Hankook Optimo H724 All-Season Tire - 195/75R14 92S come with a white wall. I rHankook on my W108.
Forum: Vintage Mercedes Forum 11-03-2022, 01:11 PM
Replies: 11
Views: 1,745
Posted By TZ_280SEL
When the check valve leaks, it allows the...

When the check valve leaks, it allows the pressure in the rail to fall below the vapor pressure of the hot fuel in the rail. It all flashes to vapor and the brief 2 second run of the pump is not...
Forum: Vintage Mercedes Forum 09-04-2022, 08:29 AM
Replies: 12
Views: 2,251
Posted By TZ_280SEL
Mercedes put an electronic box between the points...

Mercedes put an electronic box between the points and the coil. It takes a lot of the load off the points and prevents having to adjust them. BUT, as the electronics start to fail, you get erratic...
Forum: Vintage Mercedes Forum 09-01-2022, 04:48 PM
Replies: 43
Views: 5,017
Posted By TZ_280SEL
I just got back from a quick trip to Washington...

I just got back from a quick trip to Washington DC. Hadn’t checked my mileage in a while. I drove 275 miles. Probably 50 were in town (city), 50 were stop and go on I-95 getting to/from DC and the...
Forum: Vintage Mercedes Forum 09-01-2022, 12:03 PM
Replies: 12
Views: 2,251
Posted By TZ_280SEL
I had the electronic switchgear go bad in my...

I had the electronic switchgear go bad in my 280SEL 4.5 years ago. It started as a slight backfire going down hill on lift throttle. It turned into a bucking bronco of misfire and lack of power. ...
Forum: Vintage Mercedes Forum 08-27-2022, 09:14 AM
Replies: 43
Views: 5,017
Posted By TZ_280SEL
The euro 4.5 had 8.8:1 from the factory. Rated...

The euro 4.5 had 8.8:1 from the factory. Rated at 225HP due to the slight compression bump.
Forum: Vintage Mercedes Forum 07-10-2022, 09:03 AM
Replies: 4
Views: 873
Posted By TZ_280SEL
Yes, pull the rear up and it folds into the seat.

Yes, pull the rear up and it folds into the seat.
Forum: Vintage Mercedes Forum 07-10-2022, 09:01 AM
Replies: 11
Views: 1,476
Posted By TZ_280SEL
Actually, the AC evap is under the glove box. ...

Actually, the AC evap is under the glove box. The heater core is under the center of the dash. You can service the heater core in place but if you are removing it, it’s a good two days in and out. ...
Forum: Vintage Mercedes Forum 04-13-2022, 07:59 PM
Replies: 9
Views: 1,639
Posted By TZ_280SEL
When you say the “broken strut support” are you...

When you say the “broken strut support” are you talking about the strut rod from the subframe to the right frame? That would lead me to believe alignment. That strut is supposed to be loosened I...
Forum: Vintage Mercedes Forum 11-05-2021, 10:55 PM
Replies: 16
Views: 1,573
Posted By TZ_280SEL
If you pull the connector off the temperature...

If you pull the connector off the temperature sensor (single wire) and ground it, the fan should run. That will tell you the fan is good or bad. My 72 did not have a pressure switch on the dryer.
Forum: Vintage Mercedes Forum 07-08-2021, 03:40 PM
Replies: 9
Views: 1,103
Posted By TZ_280SEL
Vacuum reservoir so your locks work without the...

Vacuum reservoir so your locks work without the engine running.
Forum: Vintage Mercedes Forum 05-03-2021, 06:49 AM
Replies: 5
Views: 2,155
Posted By TZ_280SEL
I tried to resurrect my switch for a long time...

I tried to resurrect my switch for a long time but to no avail. I now have a straight 3 speed switch (high, med, low) that was a direct plug and play for the old switch. Old Air Products 24-0001 -...
Forum: Vintage Mercedes Forum 02-10-2021, 06:55 AM
Replies: 13
Views: 1,157
Posted By TZ_280SEL
I'm glad it worked out for you. Out of...

I'm glad it worked out for you. Out of curiosity, did you replace your rotors? If so, where did you find them? I can't find vented W108 rotors anyplace.....at least not for a reasonable price.
Forum: Vintage Mercedes Forum 02-04-2021, 09:59 PM
Replies: 13
Views: 1,157
Posted By TZ_280SEL
I would source new (new to you) bolts for W108...

I would source new (new to you) bolts for W108 calipers. If I remember correctly, those caliper bolts have a shoulder.
Forum: Vintage Mercedes Forum 01-11-2021, 02:09 PM
Replies: 11
Views: 1,092
Posted By TZ_280SEL
To be precise, I believe there are 14 grease...

To be precise, I believe there are 14 grease fittings on the front suspension (2 per control arm, 1 per king pin, 1 per upper eccentric, 1 per lower pivot) and two on the rear.
Forum: Vintage Mercedes Forum 07-10-2020, 03:00 PM
Replies: 22
Views: 2,502
Posted By TZ_280SEL
Not sure what your goal is with your car, but I...

Not sure what your goal is with your car, but I chose to ditch all the D-Jet and go Megasquirt. I know a lot of people don't like it, but the system has been great for me. I drive my 280SEL daily...
Forum: Vintage Mercedes Forum 03-10-2019, 03:47 PM
Replies: 4
Views: 1,452
Posted By TZ_280SEL
Your 280SEL has a vent/vacuum device on the...

Your 280SEL has a vent/vacuum device on the driver side about halfway back under the car. There is a vapor recovery tank in the trunk behind the spare tire. There are too many hoses on this car to...
Forum: Vintage Mercedes Forum 06-15-2018, 12:57 PM
Replies: 12
Views: 1,251
Posted By TZ_280SEL
I have a 72 280SEL 4.5 as my daily driver. Has...

I have a 72 280SEL 4.5 as my daily driver. Has been for over 8 years now. I retrofitted the AC with R-134, a new compressor, and a cross flow condenser.
Forum: Vintage Mercedes Forum 06-01-2018, 01:12 PM
Replies: 7
Views: 782
Posted By TZ_280SEL
My 4.5 speedo did the same thing a few months...

My 4.5 speedo did the same thing a few months ago. I ended up pulling it apart. The input worm gear shaft had broken. I welded it back together and filed the gear back. Works like new, well 46...
Forum: Vintage Mercedes Forum 03-13-2018, 04:50 PM
Replies: 11
Views: 1,400
Posted By TZ_280SEL
My W108 was also making that noise on...

My W108 was also making that noise on acceleration. Do you have the floor shift or column? Mine is floor shift and it was a worn shift linkage bushing which allowed the linkage to wander over under...
Forum: Vintage Mercedes Forum 11-16-2017, 03:00 PM
Replies: 15
Views: 2,166
Posted By TZ_280SEL
I know my 72 4.5 alternator has external voltage...

I know my 72 4.5 alternator has external voltage regulator but I know the later 450SLs had integrated voltage regulator. Not sure when the change was made but that would require some modifications.
Forum: Vintage Mercedes Forum 10-13-2017, 04:41 PM
Replies: 8
Views: 1,612
Posted By TZ_280SEL
If you look at the W108 subframe, the subframe is...

If you look at the W108 subframe, the subframe is supported by the mounts at the top. The flat springs push/pull on the horns that come off the front of the sub-frame so the essentially move the...
Forum: Vintage Mercedes Forum 08-07-2017, 12:01 PM
Replies: 19
Views: 3,622
Posted By TZ_280SEL
So if I remember correctly, the right axle has a...

So if I remember correctly, the right axle has a very particular removal sequence or you will break the clip that holds it in place. Speaking from memory, you have to remove the shocks and springs...
Forum: Vintage Mercedes Forum 07-21-2017, 11:15 PM
Replies: 18
Views: 2,298
Posted By TZ_280SEL
Yes, the Idle Air valve replaces the AAV. My car...

Yes, the Idle Air valve replaces the AAV. My car would never idle the same two days in a row. It would idle low when hot, high when cold, erratic when raining. The girl has about 500,000 on the...
Showing results 1 to 30 of 40
Page 1 of 2 1 2

 
Forum Jump


All times are GMT -4. The time now is 07:14 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page