Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 2 1 2
Showing results 1 to 30 of 33
Search took 0.01 seconds. Search: Posts Made By: sonnybuddy
Forum: Tech Help 04-16-2007, 11:37 PM
Replies: 9
Views: 955
Posted By sonnybuddy
201 front coil spring

Where (besides MB) can I find new or used front coil springs for my '88 190E?
Seems that the cold weather we had in February, along with normal aging killed the passenger side spring...I probably...
Forum: Tech Help 05-17-2006, 03:27 PM
Replies: 3
Views: 810
Posted By sonnybuddy
just bumping this up one more day

just bumping this up one more day
Forum: Tech Help 05-16-2006, 04:57 PM
Replies: 3
Views: 810
Posted By sonnybuddy
190E hot starting problem

My 88 190E (2.3 l 8 valve) has developed an annoying hot start problem.

The engine starts off just fine when cold, it's what happens after the engine reaches operating temperature that's giving...
Forum: Tech Help 06-02-2005, 02:02 PM
Replies: 2
Views: 832
Posted By sonnybuddy
Stuck window!

I have a stuck rear passenger window on my '88 190E. Both the console switch and the door switch itself will give a gentle "tick" insdie the door when I attempt to lower or raise the window. Is...
Forum: Tech Help 06-02-2005, 02:00 PM
Replies: 2
Views: 1,080
Posted By sonnybuddy
Just in time for summer...sunroof stuck!

The tilt and slide sunroof on my '88 190E refuses to open, it will neither slide, nor tilt up. (it's in the closed position right now). Activating the switch causes a LITTLE movement (i.e the...
Forum: Tech Help 04-04-2005, 02:37 PM
Replies: 2
Views: 792
Posted By sonnybuddy
Angry Now, to make matters worse, the manual says that...

Now, to make matters worse, the manual says that the window has to be all the way DOWN to remove the regulator/motor. :mad:

How in blazes am I supposed to lower the window to repair it? The...
Forum: Tech Help 04-04-2005, 02:33 PM
Replies: 2
Views: 1,179
Posted By sonnybuddy
the crank in the trunk will not ove..it's jammed...

the crank in the trunk will not ove..it's jammed alright
Forum: Tech Help 03-29-2005, 02:55 PM
Replies: 2
Views: 792
Posted By sonnybuddy
Window regulator removal...bad motor?

I have a stuck rear passenger window on my '88 190E. Both the console switch and the door switch itself will give a gentle "tick" insdie the door when I attempt to lower or raise the window. Is...
Forum: Tech Help 03-29-2005, 02:55 PM
Replies: 2
Views: 1,179
Posted By sonnybuddy
Tilt and Slide sunroof stuck shut!

The tilt and slide sunroof on my '88 190E refuses to open, it will neither slide, nor tilt up. (it's in the closed position right now). Activating the swith causes a LITTLE movement (i.e the sunroof...
Forum: Tech Help 05-27-2004, 06:57 PM
Replies: 11
Views: 1,490
Posted By sonnybuddy
As much as Hyundai has improved things in the...

As much as Hyundai has improved things in the last few years, I wonder if their parts are as hefty an over engineered as Mercedes...;)
Forum: Tech Help 05-26-2004, 10:32 PM
Replies: 11
Views: 1,490
Posted By sonnybuddy
What's the max temp you saw? ---I THINK it...

What's the max temp you saw?

---I THINK it was in the red but I can't remember


Did the flying parts hit anything and damage anything?

---not a thing, but If I still had the belly pan on...
Forum: Tech Help 05-26-2004, 08:45 PM
Replies: 11
Views: 1,490
Posted By sonnybuddy
:confused: Well so far one vote for yes,...

:confused:

Well so far one vote for yes, the engine is probably OK, and one vote for possible damage....lol I'm no further ahead than I was when I started.

For what it's worth, after the...
Forum: Tech Help 05-26-2004, 06:45 PM
Replies: 11
Views: 1,490
Posted By sonnybuddy
Have I wrecked my new engine ALREADY?

Long story short....rebuilt 2.3 Engine 190E..1500Km on the engine. Coming home today...charging light comes on....5 miles from home, I think "no problem" I'll get it home and look at it...temperature...
Forum: Tech Help 04-21-2004, 09:45 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
Yeah I really messed up the mixture trying to get...

Yeah I really messed up the mixture trying to get the engine to idle lower than 2000 RPM with the EHA unplugged.:eek:
Lord knows where it's at now. Thanks for the advice.
Forum: Tech Help 04-21-2004, 06:47 PM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Well we don't need to go any further now. I found...

Well we don't need to go any further now. I found the problem. I had the plug for the EHA plugged into the Aux Air valve and vuice versa. Putting these connections on the proper components helped a...
Forum: Tech Help 04-21-2004, 06:29 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
Well we don't need to go any further now. I found...

Well we don't need to go any further now. I found the problem. I had the plug for the EHA plugged into the Aux Air valve and vuice versa. Putting these connections on the proper components helped a...
Forum: Tech Help 04-21-2004, 12:14 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
Well I have a three wire connector at the base of...

Well I have a three wire connector at the base of the FD...but I think that's for the wide open throttle switch. If I need to run the fuel pump, I can just jump connections 7 and 8 on the fuel pump...
Forum: Tech Help 04-21-2004, 10:01 AM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Could this whole issue be caused by just a dirty...

Could this whole issue be caused by just a dirty / clogged /old fuel filter that didn't balk until the car was stored for 3 months?
Forum: Tech Help 04-21-2004, 12:21 AM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Actually I have no idea why I took this part...

Actually I have no idea why I took this part off....I guess it was one of those "hmmmm...I wonder what THIS thing does?" moments...but I'm pretty sure I didn't mess it up...just a couple of"O"rings...
Forum: Tech Help 04-20-2004, 11:41 PM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Something else I can tell you is that the only...

Something else I can tell you is that the only component from the Fuel distributor amd intake maifold that I actually removed WAS this electro hydraulic actuator...I'm wondering if I didn't mess it...
Forum: Tech Help 04-20-2004, 11:38 PM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Yes, the engine runs fine (albeit idling at 2000...

Yes, the engine runs fine (albeit idling at 2000 rpm) when this plug (bolt) is removed...it spills fuel like crazy from the hole where the plug used to be, but the engine runs...for what it's worth
Forum: Tech Help 04-20-2004, 10:10 PM
Replies: 11
Views: 10,664
Posted By sonnybuddy
Strange Fuel distributor problem 190E

After installing the rebuilt 102 engine in my 88 190e the car won't run for more than 5 seconds...Turn the key off...wait another minute...runs great for 5 seconds.. OK.

This is strange. The...
Forum: Tech Help 04-20-2004, 09:51 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
Henryk, I tried the resistance test on the...

Henryk, I tried the resistance test on the plate, and yes, with no fuel pressure it was quite a bit easier to push down (in my case) that it was with full system pressure applied...so I know I'm...
Forum: Tech Help 04-20-2004, 12:44 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
up

up
Forum: Tech Help 04-19-2004, 08:36 AM
Replies: 15
Views: 3,781
Posted By sonnybuddy
I have what's known as CIS injection I believe. ...

I have what's known as CIS injection I believe. On this system the cold start valve gets its fuel from the fuel distributor as well as the injectors, or so it looks like.

As for this plunger...
Forum: Tech Help 04-18-2004, 08:39 PM
Replies: 15
Views: 3,781
Posted By sonnybuddy
Question fuel distributor not "distributing"

Well I finally finished installing the rebuilt 102 engine in my 88 190e today. The moment of truth ....checked and double checked all connections, vacuum lines, etc. Turned the key on, heard the fuel...
Forum: Tech Help 04-13-2004, 01:05 PM
Replies: 7
Views: 2,440
Posted By sonnybuddy
Mike, do you have the same diagram for an...

Mike, do you have the same diagram for an automatic trans?

Thanks
Forum: Tech Help 04-13-2004, 11:59 AM
Replies: 7
Views: 2,440
Posted By sonnybuddy
Thanks for the suggestion. I hope there's enough...

Thanks for the suggestion. I hope there's enough room in there to get a wrench. I'll be working blindly in any case.
Forum: Tech Help 04-13-2004, 06:59 AM
Replies: 7
Views: 2,440
Posted By sonnybuddy
up

up
Forum: Tech Help 04-12-2004, 12:42 PM
Replies: 7
Views: 2,440
Posted By sonnybuddy
Unhappy 190E Shifter bushings

I recently pulled the engine and transmission on my 1988 190E 2.3

Now that the unit is being reinstalled I noticed that when hooking up the shift linkage that the nylon Bushing that goes in the...
Showing results 1 to 30 of 33
Page 1 of 2 1 2

 
Forum Jump


All times are GMT -4. The time now is 03:54 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page