Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 2 1 2
Showing results 1 to 30 of 60
Search took 0.01 seconds. Search: Posts Made By: 95e300dwez
Forum: Mercedes-Benz Used Parts For Sale & Wanted 08-06-2014, 02:30 PM
Replies: 5
Views: 779
Posted By 95e300dwez
Is the voltage regulator good that is all that is...

Is the voltage regulator good that is all that is needed in my car?
Forum: Mercedes-Benz Used Parts For Sale & Wanted 02-15-2014, 11:18 PM
Replies: 15
Views: 1,463
Posted By 95e300dwez
Blower motor regulator

I was wondering if you have it and know if it works? Looking for one cheap I am using a toggle switch for high position know.:D
Forum: Diesel Discussion 02-01-2014, 08:07 PM
Replies: 8
Views: 1,430
Posted By 95e300dwez
My water pump went out and leaked small amount of...

My water pump went out and leaked small amount of coolant out the tube coming from the front bearing. The tube dumps out by the alternator bracket. From the sounds of it you need a pump front...
Forum: Diesel Performance Tuning 01-26-2014, 11:55 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
http://www.peachparts.com/shopforum/<a...

http://www.peachparts.com/shopforum/<a href=&quot;http://s108.photobucket.com/user/2benchanted/media/IMAG0071.jpg.html&quot; target=&quot;_blank&quot;><img...
Forum: Diesel Performance Tuning 01-10-2014, 11:26 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Oil feed I just tapped the oil pressure output to...

Oil feed I just tapped the oil pressure output to npt and put a T fitting one side for feed other for pressure gauge. The return I drilled in the side of the block not much higher then needed about a...
Forum: Diesel Performance Tuning 01-09-2014, 01:57 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
I only have the turbo piston and rods and will be...

I only have the turbo piston and rods and will be setting the new rings to the turbo spec. The rest of your parts are really not critical if you ask me after looking at the inside of my motor and...
Forum: Diesel Performance Tuning 12-27-2013, 01:46 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
I would do it again with a 95 especially if you...

I would do it again with a 95 especially if you don't need over 300 HP and make sure you get a good turbo. The turbo was the problem it was leaking oil out the exhaust side seal and causing the...
Forum: Diesel Performance Tuning 12-27-2013, 11:05 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
I never monitored intake temps just egts. The...

I never monitored intake temps just egts. The hx35 is a good daily driver turbo for the 606 full boost by 3500. My get never got over 975 degree f on egts. Intake temps effect egt but they never got...
Forum: Mercedes-Benz Used Parts For Sale & Wanted 09-12-2013, 05:10 PM
Replies: 1
Views: 743
Posted By 95e300dwez
95 e300d parts & om606 parts

I have a set of good used 95 om606na pistons, rods, and rings 240$
95 E300D trans and shifter with 245,000 miles 100
98 om606 block, crank, and head they are rough shape sold

Message with offers...
Forum: Diesel Performance Tuning 08-22-2013, 03:02 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Motor status

Motor is torn down looks great for 250,000 miles. The cylinder bore looks real nice still have cross hatches on them and no visual damage. I need to get a dial bore guage to check taper and...
Forum: Diesel Performance Tuning 07-22-2013, 06:34 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Thanks for the help I messaged a couple of these...

Thanks for the help I messaged a couple of these companies about there motors. Hopefully can strike some sort of deal if my motor is no good.
Forum: Diesel Performance Tuning 07-21-2013, 12:23 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
I was thinking the same if I can save it I will...

I was thinking the same if I can save it I will if not getting a 98 or 99. I just have not found them for less then 2k complete without having 250000 miles on the motor. I have done some searching...
Forum: Diesel Performance Tuning 07-20-2013, 12:26 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
I am wondering the same might be easier to get a...

I am wondering the same might be easier to get a set of used piston and rods to put in my block. I also remember jeemu he had a na engine he used the na pistons and had custom rods built and had the...
Forum: Diesel Performance Tuning 07-15-2013, 05:57 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Well I have been enjoying my upgraded pump and...

Well I have been enjoying my upgraded pump and really showing it of to friends. I have just recently started getting some white smoke when I idle at stop lights and the dip stick tube will spit oil...
Forum: Diesel Discussion 06-06-2013, 11:59 AM
Replies: 9
Views: 2,270
Posted By 95e300dwez
I saw a thread on here where someone fabricated...

I saw a thread on here where someone fabricated one at home but you need access to some different size steel pipe.
Forum: Diesel Performance Tuning 05-24-2013, 12:32 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
We should get together this summer and I could...

We should get together this summer and I could show you the car. Are you still doing the races this might be a easy way to meet up.
Forum: Diesel Performance Tuning 05-16-2013, 01:51 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Pump is in

I have installed the pump and I am still doing some tuning on my transmission. I have quite a bit of flare on my trans but need to adjust the vacuum modulator. I have had quite of few cars with power...
Forum: Diesel Performance Tuning 04-22-2013, 02:35 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Pump arrived today started install need new...

Pump arrived today started install need new gasket for vacuum pump and a banjo fitting for the pump install. I will be getting the gasket tomorrow and then it will be time for a little test drive.
Forum: Mercedes-Benz Performance Paddock 04-18-2013, 10:27 PM
Replies: 1
Views: 1,848
Posted By 95e300dwez
I bought the H&R rear bar it does fit the diesel...

I bought the H&R rear bar it does fit the diesel but not sure if it will fit the v8. I know it is real close to the fuel fitting on the tank like 1/8 of a inch. I also noticed if you were to rotate...
Forum: Diesel Discussion 04-14-2013, 03:22 PM
Replies: 27
Views: 22,750
Posted By 95e300dwez
Nice rig wish I could find myself one thought...

Nice rig wish I could find myself one thought about importing one. What did you end up getting it for?
Forum: Diesel Performance Tuning 04-12-2013, 11:16 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Goran worked his magic on the pump he did 7.5...

Goran worked his magic on the pump he did 7.5 elements added outside alda it is set to 140 cc.
Forum: Diesel Performance Tuning 04-11-2013, 10:05 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Pump is done and paid for it will be shipped out...

Pump is done and paid for it will be shipped out on Friday. I can't wait putting new bushing in the rear end. I have also installed the new sway bar fits but is kinda close it will work though.
Forum: Diesel Performance Tuning 03-26-2013, 12:40 AM
Replies: 75
Views: 21,143
Posted By 95e300dwez
elements

Dieselmeken has made his own design and has finally found a manufacturer to make them up to his quality.
Forum: Diesel Performance Tuning 03-24-2013, 02:05 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
He said around 925 euro and shipping which should...

He said around 925 euro and shipping which should be about 150 euro. Have not got my final price yet.
Forum: Diesel Performance Tuning 03-21-2013, 11:38 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Yes the whole package 7.5 and outside alda I want...

Yes the whole package 7.5 and outside alda I want 300-350 and nice driving habits.
Forum: Diesel Performance Tuning 03-21-2013, 06:24 PM
Replies: 75
Views: 21,143
Posted By 95e300dwez
Update

Pump is in Sweden having Dieselmeken work his magic. Just had another present arrive today. H&R bar that should compliment my limo...
Forum: Diesel Discussion 03-18-2013, 07:14 PM
Replies: 9
Views: 3,083
Posted By 95e300dwez
Go for it

I have already done it to a 95 606 and if you have one go ahead and do it. I have had it modified for over 25000 miles and it has made a real big difference. I have sent my pump to Sweden to have...
Forum: Mercedes-Benz Performance Paddock 01-13-2011, 03:39 PM
Replies: 5
Views: 5,637
Posted By 95e300dwez
Rear bar

Here is a pic of the rear bar it has hoops for cargo net.
http://www.peachparts.com/shopforum/http://i108.photobucket.com/albums/n1/2benchanted/Mercedes%20606%20turbo/P1030055.jpg...
Forum: Diesel Performance Tuning 01-06-2011, 02:21 PM
Replies: 22
Views: 5,672
Posted By 95e300dwez
Hardness

Actually the cam is hardened before it is ground. Drop a cam it breaks real easy that is cause it is hardened and never annealed. Finding blanks might be hard to find. :D
Forum: Mercedes-Benz Performance Paddock 01-06-2011, 01:01 AM
Replies: 5
Views: 5,637
Posted By 95e300dwez
strut bars

I have decided on a price I would like to get $200 for the front bar and $100 for both back bars. Have not finished the bottom bar had some other car trouble to work on today. I will paint the bars...
Showing results 1 to 30 of 60
Page 1 of 2 1 2

 
Forum Jump


All times are GMT -4. The time now is 12:00 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page