Pilot Bearing

[McRoth]

Well, I got the old clutch out & found that my release bearing was shot, actually worse than shot! It disintegrated when I pulled it out & half the balls are missing it looks like! Of course the one that came in the clutch kit I got was the wrong one, I'm checking with Phil now to get the right one.
Well, my question is where is the pilot bearing? I think I found it in the center of the fly wheel, but it is covered by what seems to be a pressed in washer. I tried prying a little at it, but didn't want to use too much force for fear of bending it. Is this the right place? If so, how do I get it out? It seems OK, but since I'm in there anyhow I want to replace everything that should be replaced.

Thanks!