|
|
|
|
|
#1
10-29-2000, 08:24 PM
|
||||
|
||||
|
A guide rail pin removal tool (bolt) broke off in one of the pins that holds the right side (US passenger side) fixed guide rail in place. Then the extractor broke while I was removing the stub. I'll be trying a different type of extractor shortly, but I expect that the threads on the pin will be too damaged to accept another removal tool.
Question is, if the pin absolutely refuses to come out, is there any way to pull the head? Is there some way to remove the tensioer guide rail with the fixed guide rail in place? Thanks, Sixto Orosa Santa Clara, CA 78 450SEL 91 300SE 
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 117 timing chain & guide rail issue | delucat2 | Tech Help | 1 | 04-26-2004 06:08 PM |
| Chain Guide Pin removal | ken juul | Tech Help | 0 | 03-08-2004 11:03 AM |
| 3.0 Timing Chain Guide Rail | Evan | Tech Help | 22 | 02-11-2004 08:16 PM |
| 3.0 Cyl Head Removal Question - Guide rail Locating Pin removal | CE4me | Tech Help | 4 | 10-29-2003 05:44 PM |
| Timing Chain Guide rail near disaster | Brant Pope | Tech Help | 0 | 05-30-2002 02:38 AM |
Linear Mode
