|
|
|
|
|
|
|
#1
11-27-2006, 07:18 PM
|
|||
|
|||
|
light bulb warning lamp 1999 e 320
I checked all the bulbs, and found that the two side lamps were out, I replaced both of those and still the warning lamp is on. I also checked connections in the back and headlamps and all look fine. any ideas? is there a way to reset computer to stop the warning lamp.
|
|
#2
11-27-2006, 07:37 PM
|
|||
|
|||
|
Reverse lights OK? Folks forget to check them.
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.)
|
|
#4
11-27-2006, 07:52 PM
|
|||
|
|||
|
The metal base that the rear lamps snap into are known to go bad due to excess heat, causing a bulb warning light.
This is very common in the W210 chassis, and the only fix is to replace the rear taillamp assemblies.
__________________
Paul S. 2001 E430, Bourdeaux Red, Oyster interior. 79,200 miles. 1973 280SE 4.5, 170,000 miles. 568 Signal Red, Black MB Tex. "The Red Baron". Last edited by suginami; 11-27-2006 at 07:59 PM.
|
 |
| Bookmarks |
|
|
Hybrid Mode
