![]() |
|
|
|
#46
|
||||
|
||||
Just made an appointment to get the coolant changed finally. After all the great advice form all of you I ended up buying the following:
Red Line Watter Watter $10.49 from Canadian Tire Prestone Super Flush $3.99 from Canadian Tire instead of MB Citric Acid $24.00 Distilled Water $2.97 from Wal Mart ![]() Mercedes Benz Thermostat $23.04 ![]() Mercedes Benz Antifreeze Yellow/Orange ![]() ![]() I'll take a good look at the hoses when I'm there to see if I need to replace any them.
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#47
|
||||
|
||||
How about smaller pictures of cooling system supplies and bigger pictures like your avatar.
Sixto 95 S420 87 300SDL |
#48
|
||||
|
||||
Quote:
![]() ![]() ![]() ![]() ![]() ![]()
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#49
|
||||
|
||||
I forgot the smiley.
Let's not get the tech forum closed like the open discussion forum! Sixto 95 S420 87 300SDL |
#50
|
||||
|
||||
I believe I used up my once-in-a-lifetime option to pull something like that. Hope it was worth it
![]()
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#51
|
|||
|
|||
Hello'
Very nice and relaxing......... ![]() ![]() ![]()
__________________
Nachi11744 |
#52
|
|||
|
|||
coolant leak location
It looked to me either from top neck on radiator, or, the gasket between theplastic tank and core. A radiator shop can install a new tank for under $100.
|
#53
|
||||
|
||||
Turned out my thermostat was not good. That's what looks like caused that problem of the built up pressure in mycooling system and caused the radiator nipple to blow. I'm so happy I found that out and replaced it.
I drained the entire cooling system and filled with the Prestone flush and water. Ran that through for 15 minutes with the heat on maximum setting and went for a short drive. Came back and drained that all out. The fluid was super clean! Then I filled with water and ran for 15 minutes with the heat still on maximum setting and drained that all out. Finally, I filled up with the MB antifreeze and distilled water and topped off with the Red Line Water Wetter. Good as new!
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#54
|
||||
|
||||
I have a bad smell inside the car now after the coolant flush. Any ideas why this has happened or how to fix it?
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#55
|
|||
|
|||
smell
does it smell like the flush you used? you really have to get all of that out of the system, either draining from the engine blocks or filling and running the system with water until it is all gone (clear water)
other thoughts would be a hose or heater core but I defer on that to others with much more insight into your car |
#56
|
||||
|
||||
When I did my final drain it was only clear water that came out. I'm not sure if the smell is like the flush. I didn't smell of the flush when I used it.
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz |
#57
|
|||
|
|||
If it smells of glycol (smell the coolant) and you are getting greasy stuff on the windshield, the heater core is leaking and must be replaced.
Peter
__________________
1972 220D ?? miles 1988 300E 200,012 1987 300D Turbo killed 9/25/07, 275,000 miles 1985 Volvo 740 GLE Turobodiesel 218,000 1972 280 SE 4.5 165, 000 - It runs! |
#58
|
||||
|
||||
No greasy stuff on the windshield, just a very strong smell inside the car.
I just checked the coolant level and it is at the full mark.
__________________
1989 300CE Astralsilber/Schwarz 1992 300CE Schwarz/Schwarz Last edited by lino; 10-23-2004 at 12:16 PM. |
#59
|
|||
|
|||
![]()
__________________
Bernard Dallas, TX 89' 300SEL 228K 01' E320 48k |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|