![]() |
|
|
|
#1
|
|||
|
|||
![]()
Is accumulator for 560 SEL side specific? I purchased a set of them on Ebay and put both of them on the car. However, I could not, for one full hours, put the metal line back into the driver side one. I had not problem on the passenger side. I could keep turnning but the screw just will not bite in.
I really don't want to get the other one out just to find out there is not difference which side it is. Please help. |
#2
|
||||
|
||||
Should both be the same. Sometimes you are better off trying to get the hydraulic line attached before bolting the sphere into place (attaching the bracket)
Gilly
__________________
Click here to see a photo album of my '62 Sprite Project Moneypit (Now Sold) |
#3
|
|||
|
|||
I tried, many ways, but just could not get that thing in there. Very mad right now.
|
#4
|
|||
|
|||
Got it in, finally. Many thanks.
|
#5
|
|||
|
|||
Took me forever in my 300TE, and got soaked with fluid even though I purged out more than a liter. Had to shower in Gojo.
__________________
David 1986 300E Anthracite + ECodes + MB Mileage Award |
#6
|
|||
|
|||
I found that the trick is to leave the accumulators loose so you can move them around a bit to get the threads started. Helps a lot to leave the ends must started while getting the other end in!
I spent a while on the TE, but finally got smart and tried installing the lines in different orders, finally found the combination that got them all going. A bit tight down there... At least you wont' have to do the job again for a while! Peter
__________________
1972 220D ?? miles 1988 300E 200,012 1987 300D Turbo killed 9/25/07, 275,000 miles 1985 Volvo 740 GLE Turobodiesel 218,000 1972 280 SE 4.5 165, 000 - It runs! |
![]() |
Bookmarks |
|
|