|
|
|
|
|
#1
11-30-2004, 12:40 PM
|
|||
|
|||
95 C280 Turn Signals stopped working
Both Turning signals and Hazzard Flashers stopped working today
 - Checked & then Changed the fuses - nothing... What else can I check? Are these units integrated somehow? Scotty Last edited by ScottyP; 11-30-2004 at 01:31 PM. 
|
|
#2
11-30-2004, 07:44 PM
|
|||
|
|||
|
I would bet that your flasher relay has gone bad.
|
|
#3
11-30-2004, 08:27 PM
|
|||
|
|||
|
Where is the relay? Is this the combo relay??
Thanks
|
|
#5
11-30-2004, 10:19 PM
|
|||
|
|||
|
Kaz,
Where is the relay? Im an Electrical Eng. and can solder my relay (if I could find it). Do you know where it is and solder points? Thanks...
|
|
#6
11-30-2004, 11:34 PM
|
|||
|
|||
|
Scotty,
I'm not sure, where is your relay is, but for the W124 it is in the box behind the fuse box. When you find the relay, you have to pull it out. the little board is inthe box. Once you take it out, you will see the crack in the board. Soldier every crack/broken cercuit in the printed cercuit board. Hope this help.
|
 |
| Bookmarks |
|
|
Linear Mode
