|
|
|
|
|
#1
11-30-2000, 02:43 AM
|
|||
|
|||
|
I am installing a Alpine Navigation system in my 95 E320
and currently have it hooked up to the VSS wire from the radio harness. However, the Navigation system is not calibrating from this wire. Alpine says I need to find a different VSS output wire like the ECU or Cruise etc. Can anyone help me find where this VSS wire may be? 
|
|
#3
12-01-2000, 12:06 AM
|
|||
|
|||
|
I was afraid of that. I have a diagram of the Hall speed sensor connector but could not determine where it was. I am now pretty sure it is behind the dash cluster. Any tips on how to remove the cluster?
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 300D no go | Dusty-NZ | Diesel Discussion | 23 | 10-28-2005 04:33 PM |
| engine speed sensor (long) | dieselmania | Tech Help | 2 | 08-01-2004 11:13 PM |
| What are the speed limits (an enforcement) where you live? | Greg in Oz | Off-Topic Discussion | 42 | 07-29-2004 02:11 PM |
| 98 E320 Station Wagon Fan Speed Problem… | ssks | Tech Help | 5 | 06-11-2004 11:53 PM |
| What does this wire go??? | Larry Delor | Car Audio and Multimedia | 2 | 09-20-2002 12:58 PM |
Linear Mode
