![]() |
|
|
|
|
#1
|
|||
|
|||
eccentric bolts install question?
I have a 1995 c36 and i'm lowering it and changing the control arms. I'm also changing the eccentric camber bolts but the new ones bring two spacer washers each. I'm going to get it aligned when i'm finished but I want to make sure I put the washers in the right place. I would appreciate any help.
|
#2
|
||||
|
||||
I would go over to www.club202.com and do a search for lowering info. If there is an issue that will confront you when using just about any aftermarket stuff out there, these guys have encountered and solved it already. Also, check out the info on the rear camber arms from speedybenz. He makes and sells a fully adjustable rear camber arm for the 202. Good luck.
__________________
'96 C280 (gone) '97 C36 '05 C230k |
#3
|
||||
|
||||
http://www.speedybnz.com/
It's the only hope you'll have of getting your alignment correct after lowering. The 202 doesn't have the ability to be corrected after lowering without preparing for that while lowering.
__________________
'96 C280 (gone) '97 C36 '05 C230k |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil Canister Bolts | anhydrous7 | Diesel Discussion | 15 | 09-30-2004 11:02 AM |
water pump bolts broken? | ptmar | Vintage Mercedes Forum | 2 | 09-24-2004 09:50 AM |
Bolts -? when to replace or ok to reuse | David Speed | Tech Help | 7 | 09-28-2003 09:07 AM |
Which lug bolts to buy?? | kayooh | Mercedes-Benz Wheels & Tires | 1 | 11-12-2002 09:22 PM |
M130 Heat Riser Install Question | ctaylor738 | Vintage Mercedes Forum | 3 | 06-09-2001 12:18 PM |