HELP...M103 head assembly problems... pulley location

[ken_xman]

I am assembling my 89 300SE after having the head reworked. The head is on.... everything dial indicated and lined-up... looking good.
I am just about to put the 2 front covers back on. ..new seals everywhere, but I cant remember how the alternator & guide pulley mount.
Can someone post a pic of the front of the motor and the pulley locations & brackets????
.... as I remember. some of the cover bolts are dual use for holding brackets and I dont want to screw up the sealer.
Thanks guys. Ken

** see what happens in a few months. I thought I would never forget something so simple.

[ken_xman]

Bump
Really need help on this one. I am stuck currently. KC

[brewtoo]

Would a pic of a '90 300E help?

[ken_xman]

I think the motor should be the same or very close, if you can get the pass side- front of the pulley shot, I think the guide pulley is upper/ left somewhere. Thanks.

[jim16671836]

Both cars use the same engine, but I don't know about the other equipment??????? I will ask some questions and get back with you...Jim

[brewtoo]

Does this help?

[Gilly]

On the bracket with the shock on it for the belt tightener, that goes on the drivers side of the engine with NO washers, the 2 bolts with the washers are for the other side, those are the only 4 bolts holding on the front cover. You shouldn't need to do anything to the alternator to replace the head gasket. Don't know what other info you need.
Oh, you have BOTH timing covers (upper and lower) off to r&r the head???

Gilly