Hello, I'm going to change the "seat heating" on drivers seat on my 230CE, Ive clued out that its need to remove 5 bolts, i can remove three but two cant be remove (the 2 that sits behind the seat on the rear mountings), not enough with space. How do i do???????

forgot the question, found the document in WIS

__________________
Patrik Nilsson -83
230CE -88
230TE -87
http://www.hastonnet.se/putte/avatar-new.jpg

When I removed the front drivers seat in my w124 (93 400e) last week, I used the power seat motor to navigate the seat to a position that I could use a wrench and socket to gain access to the bolts. On the bolt closest to the drive axel, I used a short extension, with a flex adapter and socket. On the other bolt closest to the door, I used an open end wrench with an approach from the rear of the seat. I was also able to use a low profile socket and ratchet.

You might also try removing the rear, lower bench seat. It helps when trying to get your body into a position to use the tools. The rear, bench lower seat is VERY easy to remove. Just release two taps and pull and lift.


Hope this helps…..
Russell

__________________
Russell McMahon
Tulsa, OK
2001 CLK 320
1992 400se
1993 400e
2000 320ML

I agree - it's all a matter of moving the seat around - back and forth, up and down - so you've got to keep the power to the seat hooked up right up until you're ready to lift the seat out.

I dont need to remove backseat cause I dont have the B-post in my way and by that there's a lot of space between front and rear seat

__________________
Patrik Nilsson -83
230CE -88
230TE -87
http://www.hastonnet.se/putte/avatar-new.jpg