Hi Y'all -

Quick easy question, and I can't find the answer using the search function.

The outside temperature readout on SWMBO's 1993 300E has started reading too low following a good wash and degreasing of the engine compartment. I'm guessing there's some corrosion on the plug connection between the sensor and the dash unit. A quick unplug, some contact cleaner, and all is good again.

But there's the rub. I can't find the silly thing. Tracing the wires through the engine compartment, it appears to run into the fuse box. Is the plug in the bottom of the fuse box, below the fuses?

According to the ETM connection locator on the 124 shop manual CD, the connection is over near the component compartment, near the battery. This doesn't seem right, the wiring does not go anywhere near there. Also, the picture in the shop manual doesn't look anything like that part of the underhood area. So I'm assuming this is an error in the manual.

So, who knows where to find this thing on a middle-production 124 sedan?

Thx,

- JimY