|
|
|
|
|
#1
01-02-2001, 05:19 PM
|
|||
|
|||
|
I have an 85 380se with an ignition key that must be jiggled to have the fan notor come alive. Heat works fine on start up but then the temp will instantly turn cold after about five minutes (without any change in the fan speed). Nothing will make it heat again except restarting the car, in which case the heat will come back on immediately. Any suggestions?
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interesting Post on AC from the Ritter/Easley Board | ctaylor738 | Tech Help | 4 | 08-08-2003 06:36 PM |
| Plenty of heat...little heat....slow down...heat comes back | Dirty Ern | Diesel Discussion | 15 | 04-02-2003 11:48 AM |
| injector heat shields for a 300D - are they necessary? | Kent300D | Diesel Discussion | 13 | 09-19-2002 11:18 PM |
| New AC Servo and Amp, Still Full Heat | Elripster | Tech Help | 2 | 11-27-2001 09:35 PM |
| 380se heat | Skorupa | Tech Help | 0 | 01-03-2001 01:39 PM |
Linear Mode
