![]() |
|
|
|
#1
|
|||
|
|||
Need your advices on wroing with O ring
About to R & R the dryer to condenser A/C Hose. I know both ends has an O ring. My question to experts here are:
1) how hard should I tighten here? 2) do I need to use some sort of lube/sealant on O ring? Your comment will be greatly appreciated. |
#2
|
||||
|
||||
Not knowing the vehicle:
1) Back-up wrench on condensor fitting (if like mine); "snug" it up, but remember, you are dealing with soft metal on the condensor. 2) Use Nylog or refrigerant oil on the "O" rings.
__________________
The Golden Rule 1984 300SD (bought new, sold it in 1988, bought it back 13 yrs. later) |
#3
|
|||
|
|||
always remember backup.
__________________
Buy real Superb Top-Grade pure silk collections in my ebay store. |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
U-tube intake rubber selaing ring problems | H-townbenzoboy | Diesel Discussion | 4 | 02-23-2005 12:57 PM |
OM603 piston ring gap arrangement? | skleutz | Tech Help | 1 | 07-20-2004 02:15 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Diesel Discussion | 8 | 12-09-2003 12:04 AM |
I dropped a small snap ring in my transmission --can I leave it? 83 240D | Carrameow | Tech Help | 6 | 12-08-2003 10:19 AM |
W126 slip ring question (560SEL) | MikeTangas | Tech Help | 1 | 01-16-2002 07:01 PM |