|
|
|
#1
|
|||
|
|||
I HAVE A 380SEC AND I HAVE BEEN BURNING OUT COILS WITCH COST ABOUT $73.00 EACH SO I PUT A UNIVERSAL HIGH PERFORMANCE COIL ON FOR $23.00....IT WORKS OK BUT WILL IT HARM MY IGN SYSTEM.......CAN INY BODY HELP.
THANKS A LOT. |
#2
|
|||
|
|||
I doubt that the car would run if the winding ratio was too far off. If the ratio is much lower it will put a strain on the ignition module. MOST coil failures comes fron a weak secondary ignition system, ie; dist cap, rotor, plug wires where the system is always working at max output. Even plugs gapped at .060" can cause problems if the system is weak!
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Request to members in Germany - Klann or SIR spring compressor | Thomaspin | Tech Help | 59 | 09-02-2006 01:25 PM |
Voltage on disconnected coil wires with the ignition switched "on" | 87-300E_in_NC | Tech Help | 5 | 12-25-2003 03:51 PM |
1973 SL 450 Ign. Coil Resistance | quist100 | Tech Help | 1 | 06-12-2002 04:23 PM |
83 380SEC IGN WIRES | thomas jenkins | Tech Help | 1 | 01-19-2001 10:28 PM |
380SEC BURNING COILS | thomas jenkins | Tech Help | 1 | 01-15-2001 08:54 PM |