|
|
|
#1
|
|||
|
|||
240D driver's door extremely hard to close
I just bought a '78 240D, and the driver's door is very hard to close. I have to slam it so hard that I'm worried I'll break the glass. Is there any way to fix this? As far as I can tell, there seem to be no obstructions that would cause this to happen.
|
#2
|
||||
|
||||
Your description of "hard to close" is somewhat vague - like stiff or wont latch properly without slamming? If it's the later look at replacing your door strikers - inexpensive part that gives you that solid "I am closed sound".
__________________
BENZ THERE DONE THAThttp://www.peachparts.com/shopforum/...c/progress.gif 15 VW Passat TDI 00 E420 98 E300 DT 97 E420 Donor Car - NEED PARTS? PM ME! 97 S500 97 E300D 86 Holden Jackaroo Turbo D 86 300SDL (o\|/o) |
#3
|
|||
|
|||
Most likely it is a simple matter of adjusting the striker. Loosen the allens enough so that you can tap it out a little, retighten and test. Repeat until it shuts easy with no wind noise.
Good luck, |
#4
|
||||
|
||||
I would also suggest checking the condition of the check strap and greasing the hinges.
You don't say if it is hard to close throughout the swing or only at the end of travel. Keep us posted.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#5
|
|||
|
|||
I had this problem and it was the check strap binding... glad I spetn the 15 dollars to replace it...
__________________
1989 300ce 129k ( facelifted front,updated tail lights, lowered suspension,bilstein sports, lorinser front spoiler, MOMO steering wheel, remus exhaust,stainless steel brake lines). (Gone) 1997 s320 154k (what a ride). Sold with 179k miles. Replaced with Hyundai Equus 1994 e320 Cabriolet 108k 1972 280se 4.5 153k Owned for 12 yrs, sorry I sold it [/SIGPIC] |
#6
|
|||
|
|||
Sorry I wasn't more clear, but by hard to close, I meant I have to slam the door to close it. The swing is smooth, it's the latching that's a pain. I think I'll try to move the striker out a bit and see if that works.
Thanks! |
#7
|
|||
|
|||
This also happens sometimes when the weatherstripping is replaced.
Len |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Nice spring weekend: 83 240D Wheel Bearings-Replacement how hard? | Carrameow | Tech Help | 2 | 05-17-2002 04:38 PM |
possible 1980 240d purchase, questions/thoughts | dwcasey | Diesel Discussion | 2 | 02-18-2002 09:14 PM |
'81 240D Hard to start in the cold!! | Wizo | Diesel Discussion | 10 | 01-14-2002 05:58 PM |
240D hard start | apache | Diesel Discussion | 2 | 11-15-2000 06:46 AM |
240D hot hard start, blow by questions | a57oval | Diesel Discussion | 3 | 10-25-2000 10:06 PM |