|
|
|
|
|
#1
08-06-2005, 02:01 AM
|
|||
|
|||
|
mercedes 190E
Two problems. Some fool has disconnected my revolutions counter but left the wire hanging in the engine compartment, where does it connect to?
The same fool also disconnected the vacuum lines from a small switch situated on the front offside wheel arch (under hood) . Where do these go? Desrob 
|
|
#2
08-06-2005, 08:14 AM
|
||||
|
||||
|
desrob
dont be surprised if connecting them back causes some running problem. this is prob why they are not connected. easier to disconnect than fix correctly.
tom w
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.  [SIGPIC]..I also have a 427 Cobra replica with an aluminum chassis.
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "not enough (diesel) fuel injection pressure" | BenzDiesel | General Information | 56 | 05-11-2005 06:23 PM |
| 1987 Mercedes 190e 2.3 and Overvoltage Protection Relay | Eidetic57 | Tech Help | 3 | 12-13-2004 12:07 PM |
| 1992 Mercedes Benz 190E 2.3 | Bob S. | Mercedes-Benz Cars For Sale | 0 | 11-05-2004 08:34 PM |
| 190E 2.3-16 parts for sale | kiato4 | Mercedes-Benz Used Parts For Sale & Wanted | 2 | 06-25-2003 07:14 PM |
| Non running Mercedes 190E | JGrif115 | Off-Topic Discussion | 2 | 05-19-2002 07:16 AM |
Linear Mode
