|
|
|
#1
|
|||
|
|||
On my W123 body (Diesel Motor)
Crack approx. 2 “ length has been found on big cross beam. This big cross beam is welded between left frame and right frame and located under engine near oil reservoir. How can I repair this crack by gas welding? I think electric arc welding is not acceptable because may be arced between engine bearing and crankshaft or on bearing wheels etc. |
#2
|
|||
|
|||
see my reply in Diesel Discussion.
Best of luck, |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Did someone drive their 87 300D W124 300 miles with a cracked head? | Carrameow | Diesel Discussion | 3 | 10-26-2004 01:06 PM |
Why can my 85 300D climb the Shenandoahs but not cross the street... | Carrameow | Diesel Discussion | 16 | 07-09-2004 05:33 PM |
300D w123 hirschmann antenna | nibiru | Car Audio and Multimedia | 3 | 06-21-2004 11:40 PM |
Why did the chicken cross the road? | Joseph Bauers | Off-Topic Discussion | 7 | 05-28-2004 11:47 AM |
w123 300D cross beam cracked | 300D | Diesel Discussion | 2 | 02-19-2001 01:07 AM |