|
|
|
#1
|
||||
|
||||
1985 300TDt Died - Help!
Hello,
I was pulling out of the parking lot from work after I had backed out of my parking spot and drove to the exit of the lot and pulled into the street and the car just stopped going. The engine was still running but it would not go. I pushed it off the road with some help and checked the tranny fluid. It was a little low but not too bad. I added tranny fluid and it still will not go. When I move it from park to any of the gears and then back to park I hear the clicking sound like the parking pawl isn't engaged - as if the car was still rolling. Can it be a flex disc? I got under the car with the brake on and the tranny in drive to see if the front section of the driveshaft was spinning and it wasn't. Has anyone had this experience? I'm praying it isn't the tranny.
__________________
Doug 1987 300TD x 3 2005 E320CDI |
#2
|
||||
|
||||
put the car in park with the handbrake released, see if the car will roll. Do the same with the car in drive (engine off) and see if there is a difference. If there is, you have a tranny problem, if there isn't your driveline or differential might be the problem.
can you check your shift linkage? Also, when was the tranny fluid replaced last. Finally, if one of the CV joints failed in the back or came loose, this would cause no motion unless you had a lsd or locker. Strange... Have a Hopefully Happy New Years! Adam |
#3
|
||||
|
||||
Quote:
I must admit that I don't know when the tranny fluid was last changed. It was on my to do list. What I don't get is that as I am pulling out of the parking lot after I had backed out of my space and drove to the exit of the lot it was fine. When I went to pull into traffic, (I had plenty of room, so I wasn't accelerating hard) the car just stopped going. Now, when I put it in gear with the engine running, it does not go, and when I try to put it back into park I hear a sound like the parking pawl trying to engage. Has anyone experienced this? I have a natural phobia of transmission shops. I have been ripped off before. Has anyone rebuilt a 722.315 tranny? I saw a post where a guy rebuilt his own, and emailed him, but haven't heard back.
__________________
Doug 1987 300TD x 3 2005 E320CDI |
#4
|
||||
|
||||
Sounds like you may have experienced the dreaded B2 piston failure. Under load, the B2 piston will shatter. I've seen two cases where the car would take a lot of pedal to get it to move in first, but once it was going, the tranny would shift into second and everything was fine. I have heard of several others that are more similar to what you describe, though.
Take a gander at the archive. Search for "B2 piston failure" or some such.
__________________
Gary Thompson Georgetown, TX 1995 E320 1984 300D |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|