What do these scanned codes mean: 95 S280

[atikovi]

The car after sitting a few weeks won’t start and I’ve narrowed the problem down to the injectors not working. I connected a scan tool and got the following results:

Code 10 in the Overvolt Protect System: Power supply pins 38, 15 and 34 contact not well, BM module box connected wire fuse F2 open.

Code 10 in the BM system: Volts supply for fuel injectors interrupted.

Other system codes:
Code 104 MB-code 117: Attempt when starting syst performed with IF2 locked

Stored codes:
Code 15 MB-code 018 Throttle valve potentiometer drive value a little lower
Code 18 MB-code 022 CC, EFP actuator signal in limp home mode
Code 32 Fuel adaptation Lambda control mixture too rich (lean stop)
Code 125 MB code 019 Potentiometer throttle valve drive loose contact

Where do I find the BM module box connected wire fuse F2 and what does it mean when it says IF2 locked when attempting to start? What else should I check?

Here are photos of the underhood modules:

Close up: