My 95 E320 Wagon has a long crack in the windshield. I need to have it replaced. Does anyone have any advice about the national chains or any local shops in the Weschester, NY or Fairfield, CT area. How can I tell if they are using quality glass? Thanks, edge.

__________________
85 300CD Signal Red/Tan sold
83 300D Manganese Brown 109K
97 E420 Midnight Blue 197K sold
98 BMW 328i Vert White 100K, sold
95 BMW 525i White 125K, sold
93 BMW 525iT Red 193K, sold
95 E320 Green Wagon 125K, sold
94 E320 White 127K, sold
85 300SD 156K Grey (Annie), sold
84 300D Lapis Blue 170K (Judy), sold
99 ML 320 Black (lease), 1998 C230 White (lease)
00 Honda S2000 Red (lease)
86 Mercedes 300E (sold)
84 Porsche 911 Red (sold), 1965 Porsche 911 White (sold)

Call the dealer, and ask who they use. That's what I have done.
You do not want some grunt who knows nothing about MB screwing up
your car. After you find the guy, then ask him whether he has the proper
clips for the trim in case one breaks. If no then someone needs to buy the kit from the dealer. I have heard stories of idiots gluing the trim strips and the roof trim.

My experience on 2 different w-124's is that the guy shows up and does the
R & R right in your driveway. You then need to not drive the car for 24 hours to allow the sealant to cure. It's also important that they use the correct sealant to glue the glass down.

In my opinion paying extra for the Sigla glass is silly. He will probably put in
PPG. Installed cost was something like $250.00 bucks. I play golf with a guy who is GMgr of a glass production plant. I asked the question about differing hardness of OEM versus for instance PPG. He smiled and explained that glass is glass.

Steve

Had mine replaced by

Coastal Tinting
(203) 877-8468
70 Bridgeport Ave
Milford, CT

They used the same brand as the original. Can't remember the name, but its on the glass. Had to ask for it.

Tricky part to installation is getting the rubber strip that runs along the bottom of the windshield to set in properly where it goes underneath the wiper assembly. I took my wiper assembly out for the install.

How hard is it to take off the wiper assembly? My glass says, "PPG" with the Mercedes emblem.

__________________
85 300CD Signal Red/Tan sold
83 300D Manganese Brown 109K
97 E420 Midnight Blue 197K sold
98 BMW 328i Vert White 100K, sold
95 BMW 525i White 125K, sold
93 BMW 525iT Red 193K, sold
95 E320 Green Wagon 125K, sold
94 E320 White 127K, sold
85 300SD 156K Grey (Annie), sold
84 300D Lapis Blue 170K (Judy), sold
99 ML 320 Black (lease), 1998 C230 White (lease)
00 Honda S2000 Red (lease)
86 Mercedes 300E (sold)
84 Porsche 911 Red (sold), 1965 Porsche 911 White (sold)

The wiper assembly does not have to come off.

Steve

Steve's correct, the wiper assembly does not have to come off. I took the opportunity to replace my noisy blower motor; part of that procedure is to reomove the wiper assembly. Not quite sure if I'd have removed it for the sole purpose of the windshield R/R. Anyway, I think I may have caused some unwarranted anxiety.

Thanks, guys. Coastal Tinting came to the house and replaced mine for $220. He was very meticulous and did a great job.

__________________
85 300CD Signal Red/Tan sold
83 300D Manganese Brown 109K
97 E420 Midnight Blue 197K sold
98 BMW 328i Vert White 100K, sold
95 BMW 525i White 125K, sold
93 BMW 525iT Red 193K, sold
95 E320 Green Wagon 125K, sold
94 E320 White 127K, sold
85 300SD 156K Grey (Annie), sold
84 300D Lapis Blue 170K (Judy), sold
99 ML 320 Black (lease), 1998 C230 White (lease)
00 Honda S2000 Red (lease)
86 Mercedes 300E (sold)
84 Porsche 911 Red (sold), 1965 Porsche 911 White (sold)

I have heard good things about these guys, anyone have them tint their car?

__________________
2016 Corvette Stingray 2LT
1969 280SE
2023 Ram 1500
2007 Tiara 3200