02-10-2006, 02:02 PM
|
 |
California Dreaming
|
|
Join Date: Jun 2003
Location: SF Bay Area
Posts: 599
|
|
Quote:
The X11 diagnostic connector
On my 1991 560SEC the "X11 diagnostic connector" is mounted on the inside of the left fender, behind the ABS controller. It has a round screw-cap. On some cars (California?) there is also an "X11/4" between the two firewalls - don't get them confused.
The signal provided at pin 3 of X11 is called the "lambda on/off ratio" signal. It is convenient to use pin 2 of the same connector as a ground reference.
This lambda signal is not a replica of the voltage from the oxygen sensor. Instead, it is a constant 100 Hz pulse whose duty cycle indicates the hunting of the fuel injection for an ideal mixture by switching back and forth between very slightly rich and very slightly lean.
Mercedes has chosen the less common definition of "duty cycle" in this case. They are referring to the percentage of the entire pulse period during which the voltage is zero, not the time when it is near battery voltage (mine was +13.6 V when the battery was +14.0 V). In other words, if the pulse rests at ground for 7 milliseconds and then rises to +13.6 V for 3 ms, the duty cycle is considered to be 70% (see oscilloscope trace at right).
If you have an oscilloscope to measure this timing, fine. If not, it can still be estimated with a voltmeter. Since continuous "0 volts" would be considered 100% and continuous 13.6 V would count as 0%, just measure the voltage between pins 2 and 3 of X11 and divide that by 13.6. Next subtract that ratio from one, and convert the result to percent.
For example, if the meter reads 4.0 V, first divide 4.0/13.6 = 0.294. Subtract 1.0 - 0.294 = 0.706, or 71%. In equation form:
Duty Cycle = [1 - (V{pin 3}/V{max})] x 100%
Remember that if the oxygen sensor is doing its job and the system is operating closed-loop, the reading will jump around, so you might see readings from 5 V to 7 V and have guess at an average.
|
Follow these instructions to set your CO mixture and with that new O2 sensor your follow up test will have some surprising results 
|
Threaded Mode
