|
|
|
#1
|
|||
|
|||
Passage Side Vacuum Door Lock
Need Help! 1993 190E 2.6
The door lock knob will not pop up when the passage side is opened with the key. What steps should I take to correct this vacuum system problem? Thanks, Don Hicks |
#2
|
|||
|
|||
Hi Don,
I had the same problem on my '82 380SL. The vacuum unit has two diaphragms mechanically connected by a "C" shaped aluminum fitting, and on my unit one end of the "C" was loose on it's diaphragm. The screw had fallen out. I just replaced it after coating it with some gasket cement so it wouldn't loosen again. Perhaps your problem is similar. Regards,
__________________
Richard Wooldridge '01 ML320 '82 300D 4.3L V6/T700R4 conversion '82 380SL, '86 560SL engine/trans. installed '79 450SL, digital servo update '75 280C |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|