i have a 123 with 200 gas, 4 cylinder 115 engine with 175 cdt carburetor stromberg. i am planning to replce the stromberg with a single side draft carb . Pls check this web site http://www.jameng.com/products/index.phtml?section=2 i dont know which replacement carb should i buy for my 115 engine is it the C-502: Mercedes 4cyl 220 32/36 DGAV. original carb tipped up at a 15 degree angle or 503: Mercedes 4cyl 230 32/36 DGAV. original single carb mounted level instead of tipped thanks, i also with like to know if a crane 700-0231 XR700 ignition module is applicable to my bosch distributor no. 0231-170-237 , jfu4

i am not sure i understand your question but i think it means ...refers... to your original equipment carb...does it sit level or tipped up 15 degrees. then after deciding which you have you can order the kit accordingly.

if i wasnt sure i would call before ordering.

tom w

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual. It still needs upholstery redone...I also have a 427 Cobra replica with an aluminum chassis.

thanks thas the problem im here in the us for a vacation and planning to buy it from jameng. im from the philippines and cant check my car.

aha! now i understand your original post.

someone who has the same car needs to look at theirs for you and answer you.

anyone?

tom w

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual. It still needs upholstery redone...I also have a 427 Cobra replica with an aluminum chassis.