|
|
|
|
|
#1
06-19-2006, 12:05 AM
|
|||
|
|||
1989 300 E Ignition Cylinder Lock problem ?
Hi. I'm trying to replace my old Ignition cylinder lock and to put the new one.
What I did is that I drilled the hole into the lock cylinder to release the wheel and to be able to start the car. But the rest part of the old cylinder I can't take out. Can somebody instruct me please ? This is gasoline car not diesel. I already checked pictures here for diesel but it didn't help. Is it same procedure for gasoline and diesel to replace ignition cylinder lock ? Last edited by qaz; 06-19-2006 at 12:12 AM. 
|
|
#2
06-19-2006, 02:13 AM
|
||||
|
||||
|
Turn to key position 1.
Insert a bent paper clip into the two small holes in the barrel part. This should line up the outer barrel face with the inner barrel holes to insert the paper clip. Push in to unlock the spring lock on the barrel. The spring has a slope to it's end that crosses the hole that the paper clip will move down and press the lock spring closer to the barrel center line...then pull assembly toward you, along with outer sleeve. I think the barrel on yours has only one lock spring at the 12 o'clock position . If you have damaged the barrel assembly to the point where the key will no longer turn you must remove the complete lock assembly by removing the steering wheel/under dash knee panel and instrument panel and drill out the bolts to the steering shaft. Go to Mercedes dealership parts department with your title and order a complete new assembly, comprizing of : Barrel/Key(s)/lock/electrical switch. .PS....The paper clip , you need to grind the end with a 60 degree point on one side, so it pushes the spring lock inwards.....the slope on the paperclip should face in to the center of the barrel when installing into the 12 o'clock hole. .
__________________
[http://languageandgrammar.com/2008/01/14/youve-got-problems-not-issues/ ] "A liberal is someone who feels they owe a great debt to their fellow man, which debt he proposes to pay off with your money." Last edited by dkveuro; 06-19-2006 at 02:34 AM.
|
|
#3
06-19-2006, 02:32 AM
|
||||
|
||||
|
Try this link...
http://putfile.com/pic.php?pic=6/16902292037.jpg&s=f5 Just uploaded it...little fuzzy, but you can see the spring lock across the groove in the barrel. .
__________________
[http://languageandgrammar.com/2008/01/14/youve-got-problems-not-issues/ ] "A liberal is someone who feels they owe a great debt to their fellow man, which debt he proposes to pay off with your money."
|
 |
| Bookmarks |
|
|
Linear Mode
