![]() |
|
|
|
#1
|
||||
|
||||
1987 w126 420sel
on removing the water pump is there some trick to getting that bottom bolt out without removing the harmonic balancer? there is a cut out on the balancer but it's way too high. it's completely above the bolt's centerline. short of using an air saw removing the balancer is the only clean way.
any thoughts?? tks craig
__________________
Thanks Much! Craig 1972 350sl Red/Blk 117k 1988 420sel charcoal/Blk 140k 1987 420sel gold/tan 128k See My Cars at:http://mysite.verizon.net/res0aytj/index.html Pound it to fit then Paint it to match! There is only First Place and Varying degrees of last! Old age and deceit will overcome Youth and Enthusiasm every time! Putting the square peg in the round hole is not hard... IF you do it fast enough! Old enough to know better but stupid enough to do it anyway! |
Bookmarks |
|
|