|
|
|
#1
|
|||
|
|||
The right side of my rear bumper is hanging a little lower than the left side, its probably a 1/4" difference at the most (just enough to anger me!). I can see two adjustment type of bolts just infront of the bumper attaching to the car. I cannot reach these, can anyone tell me how? It will probably only involve a quarter turn or so... anyone have any answers?
Thank you for your time, Mike McKinney
__________________
1989 300CE - 269,000 km 1994 SL600 - 59,000 km |
#2
|
||||
|
||||
I have the exact same problem on my C-class, only it's on the driver's side. And if you look closely, you can tell that the trim/bumper does not line up perfectly in the wheel well! I think there are 2 clips or something on that side of the bumper that are not on properly.
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#3
|
||||
|
||||
Mike,
The 190 rear bumper is attached to the car with 6 bolts in total. There are 2 bolts (17mm wrench if I remember correctly) under each taillight in the deeper well of the trunk just besides the chassis beams. These can be loosened to re- adjust the rear-side of the bumper. At each side is one bolt (10mm wrench) that will take care of the alignment of the side of the bumper. These adjustment bolts will make it possible to rotate the sides of the bumper in regard of the rear. The side bolts can be reached through a possible "door" in the quarter panel upholstery at the inner side of the trunk or after removing this upholstery (if the "door" is not present...). If the side of the bumper was hit by something, it is possible that the plastic clamp at the side of the bumper is broken. These can be exchanged (after removing the bumper). David, You can re-adjust the side of your bumper as well. There is a plastic guidance at the side of the bumper that has to be loosened after which you can push it up and fasten it again to match the bumper height with the bottom of the fender. It is the easiest way to re-adjust the side of the bumper after you removed the lower part of the dirt panel (under the fender/behind the bumper). If you want me to, I van send you some pics of the mentioned guidance and the dirt panels... greetingz,
__________________
1990 300SL-24 1993 C250D with a minor 600+k kilometer www.MBenzNL.com(the Netherlands) |
#4
|
||||
|
||||
Steve,
Please do post pictures and step by step! I am glad to find out that this can (hopefully) be corrected with minimal trouble!
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#5
|
||||
|
||||
It can be corrected without any costs involved. I have to get the pictures from my digital camera (I can only do that with my laptop) and will mail you the pics and explanation within 24 hours.
greetingz,
__________________
1990 300SL-24 1993 C250D with a minor 600+k kilometer www.MBenzNL.com(the Netherlands) |
#6
|
||||
|
||||
THanks so much Steve; you are the best!
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#7
|
|||
|
|||
Steve,
Thank you for the help brother!!!! Mike McKinney
__________________
1989 300CE - 269,000 km 1994 SL600 - 59,000 km |
#8
|
||||
|
||||
Mike, David...no problem...not worth mentioning it...
David, you've got mail and I hope that the pictures are clear enough! greetingz,
__________________
1990 300SL-24 1993 C250D with a minor 600+k kilometer www.MBenzNL.com(the Netherlands) |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
WTB: 1990-1993 MB 190E rear bumper reinforcement bar | jeff-abalone | Mercedes-Benz Used Parts For Sale & Wanted | 0 | 08-01-2004 09:36 PM |
fs 190E cladding & front bumper | E DREAM | Mercedes-Benz Used Parts For Sale & Wanted | 2 | 01-05-2004 09:10 PM |
190E 2.3-16 parts for sale | kiato4 | Mercedes-Benz Used Parts For Sale & Wanted | 2 | 06-25-2003 07:14 PM |
need frt bumper comp 1990 190e | sscoupes | Mercedes-Benz Used Parts For Sale & Wanted | 0 | 12-12-2002 12:15 AM |
92 190e 2.6 - How to remove front bumper | smk_texas | Tech Help | 5 | 09-09-2001 11:20 PM |