|
|
|
|
|
#1
10-09-2006, 12:59 PM
|
|||
|
|||
|
Setting cam timing on 500sec
I am having trouble getting the timing marks to line correctly on my 500 sec. I can get the drivers side cam to line up perfectly but the passenger side will not line up. If I move the gear one tooth forward it is slightly ahead of the mark and if I move it back one notch it is behind the mark. I have a new chain and new gears and new guide rails and new chain tensioner. Any suggestions?
|
|
#2
10-09-2006, 01:26 PM
|
|||
|
|||
|
yes set it up behind the mark not ahead.this is normal.
__________________
David S Poole European Performance Dallas, TX 4696880422 "Fortune favors the prepared mind" 1987 Mercedes Benz 420SEL 1988 Mercedes Benz 300TE (With new evaporator) 2000 Mercedes Benz C280 http://www.w108.org/gallery/albums/A...1159.thumb.jpg
|
|
#3
10-09-2006, 01:37 PM
|
||||
|
||||
|
It may be off by up to 3 degrees even with a new chain.
Any more than a marked 3 and you will want to verify the cam notch is accurate. There may be an offset key in there put in by a previous owner/mechanic which makes it advanced with the new chain (or retarded if the key was put in backwards).
__________________
Current: 2021 Charger Scat Pack Widebody "Sinabee" 2018 Durango R/T Previous: 1972 280SE 4.5 2014 Jeep Grand Cherokee Limited "Hefe", 1992 Jeep Cherokee Laredo "Jeepy", 2006 Charger R/T "Hemi" 1999 Chrysler 300M - RIP @ 221k
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
