|
Hound
Also just thought: When you remove the seat, try to raise the rear as far as it goes (unsure the position of the rear screws right now). The "motor" driven side should be the one to go up all the way, the cable driven side won't be up all the way. Remove the end from the motor first, then use a drill chucked up to the inner drive cable and raise the other side so they are both as high as they go. You can also just use a small screwdriver on the cable-driven side and rotate the inner part to jack that screw all the way up, but it's a bit of a tedious process, but I've done it w/o too much emotional scarring..........
OH, after you shorten the outer sheath, just grease the inner cable a bit and put it back in the sheath, should be obvious.
Gilly
|
10-18-2006, 09:05 PM
Hybrid Mode
