Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 02-15-2007, 09:15 AM
Juck's Avatar
It could always be worse.
 
Join Date: Dec 2006
Location: Apopka, FL
Posts: 63
Help with Tranny please

Every morning I back out of my garage and onto the street. When I shift from Reverse to D,, there is a delay of about 3 or 4 seconds before the gear engages.

It's only the first shift of the day,,, otherwise the engine and tranny perform beautifully. I checked the fluid level in the tranny and it seems fine. I do not know for sure when the transmission last had a fluid/filter change.

Any ideas what could be causing this? Is this a sign of worse things to come?

Car is a 1993 300CE cabriolet with 90k (head gasket and wiring harness relaced by PO).

Thanks!

Reply With Quote
  #2  
Old 02-15-2007, 09:50 AM
david s poole
 
Join Date: Mar 2005
Location: dallas
Posts: 1,822
that's a pretty good indication that the trans has worn out the reverse clutches.will need at minimum a mini rebuild.but at least it's management by design not crisis.
__________________
David S Poole
European Performance
Dallas, TX
4696880422

"Fortune favors the prepared mind"
1987 Mercedes Benz 420SEL
1988 Mercedes Benz 300TE (With new evaporator)
2000 Mercedes Benz C280
http://www.w108.org/gallery/albums/A...1159.thumb.jpg
Reply With Quote
  #3  
Old 02-15-2007, 10:14 AM
Registered User
 
Join Date: Feb 2006
Posts: 34
He is correct!!!!!!!!
Reply With Quote
  #4  
Old 02-15-2007, 10:17 AM
Juck's Avatar
It could always be worse.
 
Join Date: Dec 2006
Location: Apopka, FL
Posts: 63
Thanks for the reply David.

The reverse-to-Drive delay only happens on the first shift of the day,,,,, it goes from reverse-to-drive just fine after that,, dunno if that's relevent.


'Mini-rebuild' has the same kinda feel as the phrase 'minor nuclear war' ,,,,, is this something I should get a local indy to perform,,,, or is it something for AAMCO? In your opinion,,, how much $ am I looking at,, ballpark?


Anything else I should be doing to a 90k tranny while it is off the car?

Thanks again.
Reply With Quote
  #5  
Old 02-15-2007, 05:03 PM
david s poole
 
Join Date: Mar 2005
Location: dallas
Posts: 1,822
i charge about $850 for a mini rebuild.this involves taking trans out of car,remove front pump and replace the o ring that kills most of these trans when it starts to leak.then remove front drum and replace clutches and lower seals in drum.then pull out the reverse clutches and replace them.reassemble and then take out valve body and main plate,disassemble and clean govenor screens,new filter and pan gasket and replace.where any seals and o rings are exposed they get replaced.-------the two main things that wear have now been covered.
__________________
David S Poole
European Performance
Dallas, TX
4696880422

"Fortune favors the prepared mind"
1987 Mercedes Benz 420SEL
1988 Mercedes Benz 300TE (With new evaporator)
2000 Mercedes Benz C280
http://www.w108.org/gallery/albums/A...1159.thumb.jpg
Reply With Quote
  #6  
Old 02-15-2007, 05:49 PM
Juck's Avatar
It could always be worse.
 
Join Date: Dec 2006
Location: Apopka, FL
Posts: 63
Thanks matey,, wish I lived closer so you could do the work.
Reply With Quote
  #7  
Old 02-15-2007, 07:25 PM
C32AMG's Avatar
Registered User
 
Join Date: Mar 2004
Location: new york/orange county
Posts: 639
Quote:
Originally Posted by Juck View Post
Every morning I back out of my garage and onto the street. When I shift from Reverse to D,, there is a delay of about 3 or 4 seconds before the gear engages.

It's only the first shift of the day,,, otherwise the engine and tranny perform beautifully. I checked the fluid level in the tranny and it seems fine. I do not know for sure when the transmission last had a fluid/filter change.

Any ideas what could be causing this? Is this a sign of worse things to come?

Car is a 1993 300CE cabriolet with 90k (head gasket and wiring harness relaced by PO).

Thanks!
Most likely cause of a delay INTO DRIVE is a leak in the B2 circuit, B2 piston seal and or a sticking B2 valve in the Valve body.

__________________
Steve Cattaneo www.mastertechtrans.com


03 SL500
02 MB AMG
87 560 SEC
87 300D
928S 83
85 928 S2 EURO
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 07:02 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page