Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 05-16-2001, 09:51 AM
Icesailor
Guest
 
Posts: n/a
I went through the process of replacing my drive axels in my 1982 300D turbo sedan last night. While doing this I also removed and replaced the seals with new. When I had the seals out i could easily see the axel bearings in the differential and noticed the mating surface for the axel had a center groove which looked like it was for lubricating the surface. I then stuck a finger inside to see how easily the roller bearing turned and it did not. I thought the inside surface of this was there fore a bearing surface. Now I'm chewing on this and I really think the bearing should have rolled easily. Note the old axel removed did not have galled bearing surfaces on it. Can some one tell me if these roller bearings are supposed to turn freely? If they are supposed to turn easily then I need to replace them. In that case can someone tell me if special tools are required and if they need to be machine pressed in? Eventually I hope to get the hang of these Mercedes. Thank you in advance for your attention to this matter.

Rick
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
nitty-gritty about rear wheel bearings and axle shaft Thai GI Tech Help 9 05-20-2007 07:00 AM
Differential change chronodeco Tech Help 0 08-27-2003 07:24 PM
W123 how do I remove the side view mirrors jrmd01 Tech Help 2 08-05-2003 04:16 PM
Driver's Side Door Lock rainmaker Tech Help 3 05-24-2002 09:07 PM
Tightening radiator hoses...how tight is tight? bill17 Tech Help 5 01-07-2002 10:20 PM



All times are GMT -4. The time now is 03:30 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page