Hi,

My wife told me she was driving the MB yesterday and sudenly the motor just stalled and turned off. She stopped, and started again on the first crank with no problem. The car is been running normally since that but this morning I cheched for codes and got this on pin 8 (Inyeccion / ECU):

Code 3: intake air temprature sensor
Code 41: CAN comunication from engine control module faulty.

The car is runnig ok but I'm affraid it's starting to show a simptom of something bad going on (again !!!). What do you guys think?

Thanks again,

__________________
-----------------
Juan
1995 E320 Sedan
2008 Ford Escape
RC Helicopter

Clear the codes and see what comes back. The air intake sensor is a plug with wire on the back side of the driver's side headlight - you can check to see if it has become disconnected.

juribe2

The air sensor is in the duct that crosses over the cylinder head.

Correct..and if the sensor was removed to do any service, [ like plugs, etc.]it will bring up the code.
..make sure it is plugged in and clear the codes..

Thanks for the imput. I cleared the codes yesterday and will check tonight to see if they come back.

What do you guys think about code 41 (CAN comunication)?

Thanks,

__________________
-----------------
Juan
1995 E320 Sedan
2008 Ford Escape
RC Helicopter