Do I have to remove the hub that attaches to the rotor in order for it to be resurface? They have some groove on them.

Thanks,

John

Do not even consider having your rotors re-surfaced. Not a good idea on a MB.
Get new rotors, they are cheap. Buy only ATE, Balo, or the genuine article from the dealer. Do not buy some cheapo Chinese junk rotor.

Removing and replacing rotors is simple, but you need some tools and instructions typically found in the factory manual. No the hub doesn't get removed as it's not actually attached to the rotor. You do have to know how to remove the brake caliper. You also need to replace the brake pads when replacing the rotors. Your existing pads have grooves that fit in the grooves of your worn out rotors. Do not think about re-using those old pads.

Might be best to take the car to a reliable MB independently owned shop and pay to have them replaced.

Probably not the answer you wanted, but hey, your life can depend on your brakes!

Steve

You don't turn Mercedes rotors.

__________________
2016 Corvette Stingray 2LT
1969 280SE
2023 Ram 1500
2007 Tiara 3200

unless of course they are on the car, with wheels and tires and your going down the road,,, then and only then can the rotors turn.

__________________
Closing the store
Benzbonz.biz on your smart phone or tablet.

I was thinking the same question for my car. I put on Brembo rotors a while ago. They are OK when cold but start to pulsate when they warm up. Are they just junk that should be replaced?

__________________
1985 380SE Blue/Blue - 230,000 miles
2012 Subaru Forester 5-speed
2005 Toyota Sienna
2004 Chrysler Sebring convertible
1999 Toyota Tacoma

__________________
2016 Corvette Stingray 2LT
1969 280SE
2023 Ram 1500
2007 Tiara 3200

pulsating is warped rotor.

__________________
joel

Prayers bring forth enlightenment.

If it was a warped rotor, wouldn't they pulstae whether cold or hot, and not just one or the other?

__________________
1989 300E 144K

commercial/consumer grade Brembo bits are crap..

Also, one more nod for Not turning brake rotors... You'll bring them down beyond the minimum spec... Don't go cheap on brakes..it's not worth it on a multitude of levels..

Jonathan

__________________
Blue Ridge Mercedes
Jonathan Hodgman
http://www.blueridgemb.com/
Enthusiast Service, Restoration & Tuning.
Follow Us on Facebook!
Located in the Atlanta area
Specializing in all pre and post merger AMG's including Hammers and DOHC M117 engines.
Mercedes Repair Atlanta

Very correct, the rotors need to be replaced and not resurfaced for these cars. I like the ATE ones, they are good.

__________________
1991 560 SEC AMG, 199k <---- 300 hp 10:1 ECE euro HV ...

1995 E 420, 170k "The Red Plum" (sold)

2015 BMW 535i xdrive awd Stage 1 DINAN, 6k, <----364 hp

1967 Mercury Cougar, 49k

2013 Jaguar XF, 20k <----340 hp Supercharged, All Wheel Drive (sold)

I thought all Brembo stuff was good, but I guess the cheap price should have clued me in.

__________________
1985 380SE Blue/Blue - 230,000 miles
2012 Subaru Forester 5-speed
2005 Toyota Sienna
2004 Chrysler Sebring convertible
1999 Toyota Tacoma